Tracer 900 GT Motorcycle Steel Crash Bar Crashbar Engine Guard Bumper Frame Falling Protector for Y-amaha MT FZ 09 MT09 FZ09 MT-09 FZ-09 Tracer FJ-09 FJ 09 FJ09 2015 2016 2017 2018 2019 2020

The Good: Packaging was good we'll protected, Finnish is nice also thick, welds aren't too bad.Instructions includedThe Bad: upper mount bolts are around an inch too long. I had to go to the hardware store for 12 washer/spacers to get it to fit, 6 on each side. (Btw bolts are M10 1.25 pitch if you want to buy your own get ones around half an inch longer than stock) Bars aren't didn't quite fit,I had to bend and refit multiple times. It wasn't much it was about a 1/8 of an inch off on the clutch lever side and less on the throttle side.Took about 4 hours.The Ugly: The bars are slightly A symmetrical by about an inch. I don't mind it, but something to be aware of.The helpful: do the clutch lever side first. Because the bottom mount on the other blocks the nut on the other side. You will need a hammer and a long screwdriver or 1/4" drive extension as the bolt where the clutch lever side mounts is about a foot long.The conclusion: not entirely satisfied, but they are strong and it does what it says on the tin.

Hardware is cheap frames aren't semetrical the left is 1" lower at the top than the right looks a bit odd if viewed head on. Had to modify the left side lower part because the holes didn't line up. I installed the left first before I noticed the semetry issue so I can't return because I had to cut part of the lower bolt hole. If you don't have a grinder with cut off wheel or the ability to fix random errors I wouldn't purchase this I may replace with better quality later on but stuck with these for now.