All States Ag Parts Parts A.S.A.P. Leveling Box Assembly - Right Hand fits Ford 1300 1310 1500 1510 1700 1900 1910 SBA370200230 SBA370010122

This did what I needed for my Kubota L2501. Just a note that although the range of the adjustments is spot on, you'll need to modify this slightly for the L2501. I'm guessing these have been mentioned before, but I'll repeat anyway.First, the upper bushing on the leveling box is 7/8" while the Kubota pin is 3/4". You'll need to buy the bushings below and tap or press them into the top of the box. I just tapped them in with a hammer - carefully. Cost was 8.99 and you'll need both of these to cover the 1.5" of the top link of the boxuxcell Sleeve Bearing 3/4 inches Bore x 7/8 inches OD x 3/4 inches Length Plain Bearings Wrapped Oilless Bushings Pack of 2Secondly, the lower arm was pretty tight on the three point arm on my tractor. I could pound it close, but I ended up grinding and filing on the leveling box lower forks (inside) to remove about 1/16" or so of material and now it fits like a glove.One more thing. The unit came complete devoid of grease. It's not enough to just pump grease into the zerks as this won't make it to all the threads. I just unscrewed the lower forks completely and pumped grease into the upper shaft and liberally greased the threads. Works much better when fully greased - especially when there's weight on it!Hope that helpsNM Plow

If you are looking g to adjust one side of your implements and make them work as needed then you need this hand cranked adjustable arm. You just need some Common sense and it’s efficient to adjust. Engineering is on point!

This was the second unit I purchased. Without going into detail, I destroyed the first one trying to make the fork fit the lift arm. And no, I didn’t try to return it.The fork has to be opened up at least 1/8” to fit the Kubota and patience is required to use a grinder to remove metal from the inside surfaces of the fork. Get that done and press 7/8” to 3/4” bushings into the upper connection point (which was easy) you are good to go.Once made to fit, works greatSomeone could make some $ making a leveling box specifically for Kubota.

Nice part, well built. Just did not fit my Kubota B3200.

Works great but had to modify a little to fit it to my Kubota

The Leveling Box Assembly for our Ford 1310 tractor fit perfectly and was an excellent quality part.

I put this on my compact tractor and it bent on the first use. No down pressure and not even stressing it. Just mowing the hay field and when I got done I noticed it was bent. Contacted the seller about a warranty return since it listed a warranty and it was past the return window. They directed me to Ag States Ag Parts as the manufacturer. Ag States refused to honor the warranty saying the seller wasn't on their list of sellers. Amazon's response was "contact the manufacturer". Dead end on a junk part from Ag States Ag Parts.

The unit works as designed, but it‘s almost impossible to crank up or down with a heavy implement lifted off the ground being supported by the leveling box. Heavy implements need to be resting on the ground to relieve the pressure on the leveling box before it is easy to crank.