J**Y
Do not order from this seller, you will not receive the item/items you placed and order for.
Do not order this item. I tried ordering it twice, both times the package was delivered to my house, the package contained the wrong items. I returned the wrong order the first time and tried ordering it again, hoping the order was filled correctly but once again it was not correct.
B**C
a correction for the converter output uses the orange +vcc and the black is neg, ground not
product arrived in a great and timely manner,great shipping. This comes with no wiring diagram ?!!!However do not fear,Im a controls guy so here is what you do for simple hookup.If you haven't already ,hookup the main motor controller wires together,the largerAWG#10 wires to AWG#12 depending on wires size just connect the larger colored wires together. yellow to yellow on control, green to green and blue to blue .Next, be sure to plug in the hall effect sensor wires into the supplied harness. Next the throttle wires will be all together on a separate harness, you can separate wires and use the brown+4.8v to +5VDC constant power, The signal wire is white wire and is a variable output 1.8VDC to 5VDC, ,and the black is the neg ground. ,Next install a 40 amp inline automotive fuse from the battery supply!! and then hookup the main supply power red 48VDC+ and then the Black neg.ground wires to the controller.you will not use the two remaining small red and black connectors .the small one is the 5VDC display ,the other red and black connector is for the48VDC charge port but you.may or may not use this for charging? THIS CONTROL is awesome and works very well.First you have to connect orange and red together{jumpered or wired through a normally open key lock switch when closed will powerup control }you can select either a high or low speed. { for low speed connect gray to black}N.O,. Next for cruise control,cruise control when switched on,just release the throttle setting and it will maintain, if you engage the throttle while in cruise it will automatically release the hold for cruise, {for cruise connect blue to black} N.O., Reverse { connect brown to black} N.O, reverse operates at a reduced speed,.To use the Brake light or any other operated switch choose either wire set {connect orange to black} it will activate the output. ,The Brake light or activated output can be used for any 12volt DC limited power source or light,lamp etc., use the purple wire for the 12VDC.and the black for negative ground, I hope this helps all who use this I would not want anyone to give a bad review just because they cant wire it up properly,Good luck Fans .by the way Try using a 6 to one ratio for sprockets and also use an idler pulley.i chose T8f chain and a T8f sprocket 54 tooth custom welded to a 19MM hub for my schwinn trike,The Vevor 9 tooth drive motor works well for power to carry a200lb person 30 mph on a trike using 26" wheels
S**N
Don’t buy
The other review is right don’t buy I got a dolly instead of a motor.
Trustpilot
1 week ago
3 days ago