(Pack of 2 Pieces) Chanzon KBPC5010 Bridge Rectifier Diode 50A 1000V KBPC Single Phase, Full Wave 50 Amp 1000 Volt Electronic Silicon Diodes

I used this product as a component for a motor speed controller. Great value for the money, worked seamlessly for the project it was used for.

My Astron RS-35M power supply is from ’94. It originally had two 1N1184A half wave diodes. Voltage drop was appx. 0.25V with 12+amp load. I purchased this pair of KBPC5010, installed them in parallel using 12ga solid wire. I used heatsink compound and attached them both to the bottom of the chassis. Voltage drop is .09v with 12+ amp load. Very impressive.Continuous running @ 13.87 v & 12+ amp load for 15 minutes output is steady and KBPC5010 do not even get warm.I had an old KBPC2502 bridge rectifier. It weighs 29.1 grams. The new KBPC5010 weigh 17.1 grams each.Perfect price for the pair and great product.

I was disappointed as I thought it was a flux capacitor. Got shot by the terrorists. My Dad never got to be a famous author.On the other hand I used this bridge rectifier in a successful LED light installation. AC from engine pigtail converted to DC for the LEDs. Works great. I do recommend getting a capacitor to eliminate the flicker. I installed it under the snow blower instrument housing with some Velcro. You can use a screw if need be.

Nice build, fit and finish. If it fails under its rated load I will update with a follow up review.

Worked for running a DC tread mill motor on AC 110V along with a couple other parts.

capacitors were not required for my install. No flicker at full throttle which is where i always run the blower. It may flicker at half throttle but i never run the machine at that.

This unit has significantly greater capacity than the original parallel units installed in my Astron 35 amp supply. I could have probably rewired to use only one and still have greater than original current carrying capacity, but I chose to retain the original configuration that only uses half of each bridge. I also chose to replace the original 2N3771 transistors with 2N5686's that have MUCH better specs. Even though they are more expensive, I would rather spend a few bucks now than need to make another trip to replace failed components again.

The product did exactly what I needed it to, I used it to convert the DC power of my treadmill motor to AC so that I can plug it into a wall outlet.

Für meine Zwecke haben die Teile sehr gut funktioniert.

40Aの定電圧電源の修理に使用しました。

制限電流、制限電圧ともに十分に大きく、安心感がある。用途は、音楽信号から低音部をフィルターで切り出して整流し、音波の包絡線からなる超低周波の電気信号を作ること。LEDを点灯させたい。使用する段になって、４つの端子のどこに交流入力を、どこに直流出力を接続すべきか、分かりにくかった。ひとつの端子にはACとあり、その隣には＋とあるが、もう一つのACがどれか、ーがどれかが分からない。テスタで導通を調べると、＋とあるのは実は出力DCのー極であった。その対角にあるのが＋極。ACと表示されている端子の対角にあるのが相手のAC端子となっている。４個の製品が、皆、同じように表示が入っている。４つの端子のそれぞれに表示を入れるべき。初め接続を間違えて、動作しなかった。それによる破損の恐れは無いが、原因究明に時間がかかってしまった。使用する人は、ご注意を。