🚀 Elevate Your Robotics Game!
The TIMESETL 5Pack L298N Motor Drive Controller Board is a high-quality, ready-to-use module designed for Arduino enthusiasts. With its robust L298N driver chip, it supports dual H-bridge configurations for driving various motors, ensuring efficient and reliable performance. Compact in size and easy to integrate, this module is perfect for DIY smart car projects and other robotics applications.
J**J
Good, I just didn't pay attention
Got for a robot the motors needed more current, they didn't fry the modules but wouldn't move. Tried on smaller gear motors and they work great. It was my fault, the riding toy I was converting could carry ~200 lbs or ~92kgs and 12volts times 2 amps is only 24watts so I should've known better.
A**R
Rugged, flexible and ready to work
This has been a good purchase. The units do a good job self protecting themselves against heat and over current draw. They start generating a lot of heat as you get to the 1A mark. The heat sink works well if you blow a small fan across it.It also provides options to use or not use its 5V power supply, PWM pins etc. It has logic protection against raising forward and backward logic pins together (although both get connected to + rail netting to zero difference). It has back EMF protection diodes to allow push back into power source.The common power rail has advantages and disadvantages between the two output sides. I’ll have to verify technical specs to see how high of a frequency PWM can drive. I have run up to 40 kHz with good response.I did end up using pull up resistors and a NPN darlington array to drive it at 5V as I eventually toasted one of my older raspberry pi’s which is only supposed to run at 3.3V
J**T
They work... but they are cheaply made
All of the drivers in the pack work 100%. The giant heat sink does a good job.The headers however are low quality and some the screws would not turn as they had been forced improperly into the threads.Overall, it's still good value for money.
T**.
so easy and reliable
Very reliable when used for the rated 35v, so if you push it to 48v ( like I may or may not have done ), wear eye protection in case the capacitors explode.
K**N
Worked for my present needs
Have only used one so far. That said, it works like stated. Eventually will get to use the rest from the pack. Seems cheaper to buy in the pack against each unless you plan never using any more than just 1
C**T
Great Motor Controller
Each motor controller can handle two motors independently. Simple to use and will handle your project needs. I am using them for a tank being controlled by a raspberry pi.
D**.
Just what was needed
Work fine and seem to be high quality
M**T
good H-bridge
I use these as motor drivers for robots
D**X
Qualité correcte et bon fonctionnement
Fonctionne parfaitement. Utiliser pour piloter de petits moteurs DC et des moteurs pas à pas.Pour les pas à pas, la plage de vitesse n'est pas très importante, mais on est loin d'un vrais driver.Le pilotage a été fait sur arduino et micro contrôleur microchip sans soucis
M**Z
Perfecto
Todo bien
C**N
Buen producto
Todo correcto
Trustpilot
2 weeks ago
1 month ago