MBRPT5051 5" O.D. 4" Inlet 12" Length T304 Stainless Steel Angled Rolled End Exhaust Tip

Well, not really much bad things I can say about it. I mean, it's just an exhaust tip. It creates a great low sound. The only reason I bought this is because the MBRB 4" exhaust system didn't come with a tip. With that being said, it is best to cut the rear exhaust to meet the measurements when installing the tip to get rid of majority of the drone. If you don't cut the pipe and just install the tip to the full length for looks, it will drone hard. Other than that, It works fine.

Great accent for my truck

I bought this because I had some amazon gift cards from returning books, so it was basically free. I installed it on the 3" down pipe to 4" pipe in my 97 f250. It went on very easily and took about 5 minutes to put on (4 of which were getting the ratchet and correct socket and then putting them back in the tool box.) It has been holding its shine pretty well, even without polishing, with the occasional wash. The only drawback is that the exhaust system I got was designed for no tip, so it needs to be cut a little shorter so that the tip isn't sticking way past the body line.

Good, not great... It looks nice and yes, like everyone is saying the picture is wrong. MBRP is stamped into the metal on both sides instead of what the picture shows. My gripe about this tip is the clamping system they chose to go with. See my attached pictures. I did tighten it more after I took the picture. This does make the exhaust note deeper and I really like that. 05 Duramax

Arrived in a nice MBRP box surrounded by foam. Tip clamped on nicely to the end of the MBRP exhaust system. Had a good shine and seems tobe holding up good this winter. Down side to this tip it's it's very hard to keep clean. Dirt hits it and bakes on it and is very hard to get off. I'm sure this goes for any exhaust tip though. Very pleased

Just got it in today, took more time to get the box open than it did to install it. Looks great, when they say mirror finish they me mirror finish. I could actually shave looking at this thing. looks nice, and was able to extend my exhaust out a little more, which took care of that interstate rumble i had when cruising, cause the sound waves were bouncing off the inside of the bed of the truck. Thanks Amazon, and MBRP ..

Fits great. Not as what the picture shows but it doesn't bother me to terrible. I live in pa so curious if it will pit or not during the winter months.

This thing looks nice, changed the sound slightly on my 4" exhaust on my 2006 2500HD Chevy (for the better). Now my high idle doesn't sound quite so intense (which the wife and dogs are happy about), and it projects the exhaust noise a bit better. Easy to put on, easy to clean, easy on the eyes and wallet.

Was extremely happy with it.and the fast delivery. The price was the only thing I didn't like.but thanks for nice product

Very good quality, easy to install

Quality exhaust tip, adds the finishing touch to your exhaust system. Easy install

Looks and works great!

Not exactly like the picture