Aluminum Motor Mount Quick Release Motor Base for 1/5 X-MAXX 6S 8S XRT 8S 77086-4 RC Truck (Black)

This motor mount worked fine for the xmaxx runningbelt drive,does require aluminum motor plate on stock xmaxx motor.I also used the aluminum mount retainers under the chassis,So far it has held up to 3 x45min runs and no slack on belt and no issues very happy customer also this mount is definitely comparable to the ones selling for much more money.

This does not fit the xmaxx stock motor or other similar size motor (hobby wing). I had to modify it for it to kinda work (drill new holes).

Works as it should using the Hobbywing 56118 800kv motor.***Dry Fit Everything First WITHOUT the motor and no Loctite******DO NOT COMPLETELY COVER YOUR SCREWS IN LOCTITE*** ( Doing that will cause major headaches later on)Takes a little patience, because the 2 main pieces have to be assembled from below like you're putting on a stock mount.Would've been nice to have one solid piece. That's the only downside. It's the only reason why I gave it 4 stars. Otherwise great quality and durability.Use a small amount of "Red Loctite" on the tips of the 2 screws in the rear where motor mount sits flush with the chassis near the pinion gear only (These screws are the ones used underneath the chassis)Use "Blue Loctite" on the tips of the 2 screws (from underneath the chassis, closest to your ESC.Install the small slide piece on the motor using "Blue Loctite" on the tips of the 4 screws.Slide motor between the posts.Using the provided top bracket, use "Blue Loctite" on tips of the 2 screws in each corner at the top.*DO NOT use loctite at all on the Center Screw* (It's used to set the mesh, it raises and lowers the motor.)Same process goes for the side bracket screws that hold your motor in place, once you've set your mesh. Blue Loctite on tips of 4 screws.I only received one side bracket (not sure if that was a mistake and I should've received 2 side brackets) but I made it work using washers.I used stainless steel screws instead of the ones provided. (My personal choice)Also I didn't used the provided support bracket that goes underneath the motor. I instead used a dense foam after I took the picture above.

Easy installation and perfect fit with my hobbywing 1100KV. Definitely a better deal than all these other overpriced adjustable mounts.

For the money you can’t beat it, I’ve used the hell out of it with a max5 combo in my xmaxx. Jumps, flips, wrecks. It’s held up perfect and holds mesh.

Nice and durable but then again it don't fit my motor. Hopefully #4 motor mount shows up and fits it. If nit I'm finding a different motor

does not go low enough to get the motor shaft into transmission housing, and does not bolt up to a hobbywing 4985

Use loctite and it works as well as others ...xrt with hobbywing 800kv max5

Fits my 1100 kv motor in my xmaxx perfectly. On a 30t pig on it clears but it would over heat so I put in a 23t arrma d8 safe pignon but the motor mount neded slight modifications. Perfect