GSTOP ® G-Force Brake Light Flasher - Accelerometer EBLD Brake Force Warning System (Emergency Brake Light Display)

Excellent bit of kit!Test harness was great, I was able to test how it works, I stuck to the dash to see how much force is required to activate the system.Install was very easy, the module itself it very small, the supplied connectors made it a doddle and have grease inside so should to some extent stop water getting in and corroding the connections.Simply cut the positive line and use the 2 supplied connectors to attach the red wires. Splice into the ground and attach or cut the ground and use the supplied connector.Once fitted you could always adjust the angle it sits at to change how much braking force is required to activate.Overall for a £8 product it is a great bit of kit.

The media could not be loaded. A simple and cost effective way make yourself more visible day and night.This was easy to fit though I had to solder my connections as the wires on my MT10 were too thick for the included terminals.Under normal braking your brake light functions normally but under more harsher braking it flashes until you release the brake lever. I'd like to see the light continue to flash after brake release under some internal relayed timer for a few seconds to keep those behind alerted once you come to a stop. This is only a preference and by no means a grip on what is an excellent bit of kit.If you do one thing to help keep you seen and safe fit this.It's less than a tenner so why wouldn't you?

All you need to get it working is included and the installation is very easy. I just used other connectors and I had to make a flat horizontal surface to mount it. It's hard to find one on my NC750S.Because it was really cold the last weeks here in Germany I only did a short ride to test it. I did a minor breaking and it worked as discribed.I attached another single led to the handlebar so that I was able see it working. The wires still can be seen in the picI would buy it again

Couldn't get it to work even by doing an emergency stop and slamming on the brakes. Would only flash the lights if you tip the unit on its side... and yes I did have it pointing the right way..! Returned.

Easy to fit but not that effective in my car

I honestly think this gadget will save lives! Simple enough to install by bypassing the brake light positive signal. Adjust the angle to suit and you're away!Just as third brake lights became standard on cars, I can see these flashing modules becoming standard in the near future too.

Easy to fit and works a treat. You really have to brake hard for it to work, which is exactly the point.It's legal because it maintains a solid light when the brake is applied when the car is at rest.

Works exactly like it said.. easy to install and much better than the cheap versions.... at least this one is legal for road use.

Make the easily available. This product works great. I put in on my car my moms. It adds a level of safety with out blinking expect on harder stops, so this way it’s not annoying the drivers behind you. Great product

Ich hab den GStop bei meinem Motorrad eingebaut, da ich oft das Gefühl hatte das die Autofahrer nicht sehen wenn ich wirklich stark bremse.Das Paket kam recht zügig bei mir an. In der Verpackung liegt alles was man braucht. Auch selbst abdichtende Klemmverbinder liegen bei, so das man nicht löten braucht. Anleitung und auch ein Kabel zur Funktionsprüfung liegt dabei.Beim Einbau muss man nur das Glück haben direkt eine waagerechte Ebene zu haben, denn sonst stimmt die Kalibrierung nicht und der GStop funktioniert nicht wie gewünscht. Ich hab mir dazu ein kleines Alublech eingeklebt.Die roten kabel werden zwischen das Signalkabel der Bremse geklemmt und das schwarze kabel an die Fahrzeugmasse.Im Stillstand des Fahrzeugs funktioniert das Bremslicht ganz normal, also auch bei der TÜV Untersuchung ist der GStop nicht wahrzunehmen. Ab 0.6 G, also bei stärkerem bremsen geht dann das Bremslicht in ein Blinken über.Für 9€ ein nettes kleines Gimmick und daher auch eine klare Kaufempfehlung!!! Und was bei Mercedes, Audi und Co viel Geld extra kostet lässt sich hiermit leicht selbst einbauen.Nachtrag: Habe nun auch bei dem Motorrad meines Vaters den GStop verbaut. Hier ging das Ganze in 5 min, da die Bremslicht Kabel gut zugänglich waren und die Fläche zum Aufkleben Gerade war.

Es un accesorio perfecto para la tercera luz de freno. Su funcionamiento es muy simple, si frenas fuerte parpadea 4 veces con una cadencia lente, y luego se queda fija, como siempre. En caso de frenada muy fuerte, da 4 destellos muy rapidos, luego 4 mas lentos, y finalmente se queda fija. En caso de frenadas normales se enciende fija. Viene con todo lo necesario para instalar, conectores, cableado y adhesivo de doble cara.

Works great! Easy install. Seems pretty effective too.