Car OBD2 II Enhanced

this extension cable makes it easier to take the the obdii device outside the cab while i am working on the car.

Cable fits the obd connector nice and snug (tighter than my scan tool connector) which is nice when using a wired scan tool that moves the cable around when using it and can come unplugged which could be troublesome if you’re in the middle of updating or coding/programming a module. This cable allows me to have plenty of slack with its length in addition to the scan tool’s cable so i can move the tool around without fear of it coming unplugged. Would recommend for sure

The cable looks to be well constructed and is as flexible as you could expect, given the rugged outer sheath. I had hoped to use it to connect a trickle charger for the car battery during long periods of non-use, but I received conflicting responses to my request for information about the gauge of the wire used. So I borrowed an accurate milliohm meter and measured the end-to-end resistance of each wire. The result was 205 milliohms (0.205 ohms), which is consistent with 26 AWG wire for a 150 cm length. This is fine for your typical OBD2 monitor but too thin for the 3 amp current my charger generates, so I’ll have to buy the connectors as DIY items and craft my own extension with at least 18 AWG wire for pins 4 and 16.

Nice, heavy duty cable. It's just the right length.

Bought this for my xtool d7 and it fits and now I can sit it on my passenger seat good deal