• Simply turning the shaft of the turnbuckle pushes the sink back into place with ease..
• No drilling into the countertop and works great in tight clearance situations. No need to remove the sink or plumbing..
• Professionally made and designed by a granite fabricator..
• Heavy duty brackets with 680 lbs. capacity. Patented..
• Please note- only 1 kit is necessary for the average fallen sink because each turnbuckle has a double headed sink bracket at the top that pivots to provide 2 points of contact for the front as well as the rear portions of the sink. Each turnbuckle takes the place of 2 supports. Therefore, 2 turnbuckles equals 4 supports plus the front center ratchet totaling 5 points of reinforcement..

The NEVER FALL will repair your sink with ease without the need to remove the sink or plumbing supply lines, drains, and any other accessories, like garbage disposals, wiring, etc. It’s professionally made and designed by a granite fabricator after seeing these problems time and time again. It takes a lot of effort to push up the sink with all the plumbing and accessories attached, especially while laying on your back under the sink and trying to screw something to the cabinet wall at the same time. Trying to multitask this situation is difficult at best but with TNF, these tasks are simplified with no aggravation. The installation is a breeze, just insert the double-headed sink bracket into the flange of the sink. Then, peel the double-sided adhesive tape from the back of the wall bracket and press it against the cabinet wall. The temporary adhesive allows for hands-free operation to install the four screws that are provided. Simply turn the shaft of the turnbuckle until the sink raises and makes contact with the countertop. Next, tighten the lock nut and you’re done! The optional front center sink support ratchet bracket and repair clip are also provided for extra support in the front for the center of the sink if needed. Simply install the repair clip to the upper front frame of the cabinet with the two screws provided. Then, slide the ratchet bracket into the repair clip and secure with one bottom screw. Finally, just push up the ratchet bracket till it meets with the sink and countertop. The Never Fall is a bulletproof system that will last as long as your kitchen even supporting 680 lbs and can be used with cast iron, composites, and stainless steel sinks. Comes with an instructional manual and a link to a repair video. The Never Fall (TM) will never fail you! Life Time Warranty. Patented. Also available for corner sinks. Includes 2 Turn Buckles, 1 Ratchet Sink Bracket, 1 Repair Clip, 12 screws, and Instructions.