ARRIS 100X250X1.0MM 100% 3K Carbon Fiber Sheet, Carbon Fiber Plate Twill Weave Panel Sheets 1MM Matte Finish, Available for 0.5mm-6mm Thickness Carbon Fiber Board

The carbon fiber looks great! I bought the matte 6mm thick one and it’s solid as a rock. I could have easily gone with the 3-4mm thick one for my project and it would have been plenty. If you are looking for a solid sheet of carbon fiber, this is it.

No surprises, what I ordered and what I received. Delivery was on time and quality good.

I bought this to make body mounts and electronics tray for an rc crawler. Quality seems pretty high, nice and easy to work with, definitely durable so far for what I've used it for. I have painted the pieces I've made so don't expect it to be colored.

liked the finish and stiffness of this carbon fiber sheet. no problems cutting on waterjet 1/8" was my smallest hole.

Looks good, feels great, nice even layers. For straight cuts I HIGHLY recommend using a tile saw with continuous rim diamond blade. I bought the cheapest I could find, & used the continuous rim diamond blade that came with it, & got flawless straight cuts!!! You can even do some minor shaping using the side of the blade i.e. knocking off sharp corners. Just be sure you keep plenty of water for zero dust.Purchased the 2.5mm plate, it's extremely stiff, like 1/8" 304 stainless steel plate stiff, just a hair over the length & width, but not quite 2.5mm thick. I had one cut-off piece that was 1.5mm wide, I bent it 60 degrees and it still did not crack or break!I measured in 20 different places along the outer edge, average thickness was just 0.0947" (2.405mm) with the minimum being 0.0902" (2.29mm), and maximum being 0.0978"(2.484mm) .... 2.5mm is 0.0984252" so even the thickest point did not measure 2.5mm. Length & width are 11.8193" x 11.8334" or 300.21mm x 300.57mmPurchased to make a custom battery box for LiFePO4 12.8v battery I'm building. This will be the outer box with 1.5mm fiberglass plates between each cell.Unrelated to the project the plate was purchased for... the plate has a very musical quality to it. I might try to make a mini-wind chime out of the scraps!!!******EDIT 3-1-2024: added two new photos of my cut on the tile saw. ******

I made a switch panel for my boat out of this carbon fiber panel. Looks great!

I'm using this as a print surface and the quality of this piece is amazing. The surface is smooth as glass, but is more of a satin finish on it. It's a perfect 300x300mm dimensionally and its flatness is better than my PEI spring steel sheet.

This one came as pictured straight lines on the fibers but blemished cuts.

High quality carbon fiber sheet. Will not hesitate to reorder Arris products. Very satisfied.