Amazon Basics PLA 3D Printer Filament, 1.75mm, Black, 1 kg Spool

I purchased this TPU filament to 3D print some phone cases. I set the temperature at the recommended 210c with the bed heating element switch off. I have to say the print was excellent! There was very little clean up, a few minor bits of stringing around the camera lens cut out and charger port, but the filament literally brushed away by hand. I wasn't expecting much of a sheen with this filament however it really does have a silk look to it. Really impressed and will definitely be buying this again!I hope that you found my review helpful

Using the red TPU and it prints very well. So far tested making a few cable ties and a 40x40x2 mm cube. Sticks well to the bed and prints with good dimensional accuracy. Flexible as expected, stretches a little, and well with a model designed to stretch (such as cable tie with loops).Settings:Nozzle: 0.4 on a direct driveTemp: 220c and 210c (no problems with either)Bed: offSpeed: 60mm/s to 5mm/s (for short loops, probably could go faster)Retr: 3mm (didn't do a retraction test so could be suboptimal)

Well packaged , comes with a great ziplock bag for storing when not in use , A+

Worked well, 60c bed 200c extruder. Not keen on the finish, this might just be what silk is like but knocked it down 1 star as I don't like the finish.

I was quite surprised by this packaging, I'd bought some Amazon Basics TPU before and it came with a decent resealable bag and several packets of desiccant. This had no desiccant and the bag, while should have been resealable, was heat-sealed under the seal that you'd use to close it up, so there was no way of using the bag for anything

The filament itself is fine and looks nice enough, but the filament seems very mildly tangled on the spool and needs attention to help it off occasionally. I left a print going overnight to discover that it had completely failed to unspool, pulling my print head off course, eventually snapping the filament. I thought this was perhaps a quirk occurrence, but have since had to nurse it through similar tight spots.

Seemed good value for money and prints ok but the spool, although sealed in a plastic bag, had air in the bag so not properly vacuum sealed. Comes with resealable bag but not with valve to suck the air out so of no use. A little disappointed.

Stuff just flows, gives a great finish, can't really fault it