DeWalt GOGGLE Concealer Clear Goggle DPG82-11D

These are comfortable and actually seal your eyes from dust or chemicals. I have not had any steaming issues and the FOV is very good. These replaced safety glasses for me.

The protection is good, I wear over my glasses with no problem. I would buy again

Over the years I have purchased many pairs of work goggles. Well, actually only two pairs to be honest. However, the point is that my previous pairs were, I will admit, cheapo ones and disappointing. I have always found work goggles to be somewhat uncomfortable, mist up a lot when my work energy levels are at fever-pitch, and frankly, as a result of that, I have done jobs where I should really have worn goggles but declined because of their frailties.Along come these DeWalt goggles: I had a couple of dirty jobs lurking on my to-do list and decided to invest a few more pennies than usual on some new goggles. I saw these DeWalts and the reviews seemed very good. I never thought that I would be adding myself to the list of reviewers -- after all, they are only goggles!They arrived yesterday, I did the mucky job wearing them yesterday, and I am sat here at a ridiculously early hour today writing a review about them. They are brilliant. I don't wear spectacles normally and so find that kind of furniture sitting on my face to be a bit strange but I can honestly say that on several occasions during the two hours I wore the DeWalts for, I actually forgot I was wearing a pair of goggles. They are SO comfortable it's quite amazing. Here's a list of the good things:1) They are supremely comfortable considering the function they have to perform.2) They are very solidly made - but lightweight too.3) The vision from them is frankly flawless and I think this is one of the main reasons you can easily forget they are strapped to your head. Not sure if it's the very curved shape of the lens, or just the quality of the lens but I had no noticeable reflections or visual hindrances at all.4) There was no misting up at any point during my fervent activities.5) They stayed in place.6) The yellow part is nice and soft and sits very gently against the face.7) My wife wears spectacles and found that the DeWalt goggles sat completely over them and fitted her just as well as they fitted me (which has to be a design achievement, as we are very different physically).8) They make you feel very protected but with minimal discomfort.9) They are a little more expensive than some other goggles -- but I feel still represent very good value for money.I wouldn't want to go shopping in Tesco in them, or take my wife out for a meal wearing them (me - not my wife!) as they, in my humble opinion, don't enhance my good looks. But I would definitely award them 10 out of 10... or 5 out of 5 as Amazon star ratings permit!If you want a pair of work goggles that perform very well then I hope that my experience with these goggles puts them on your "Goggle Consideration List".

Look good, but not exactly one size fits all! For me, they are not flush to the face (wider face than some, but not hugely so) since they are not flexible. Despite their fairly wide rubber seal, they leave quite a large gap around the middle, either side of the nose, not as much over the nose bridge itself; the gap at the bottom is MUCH bigger (about a finger's width) than at the top. It remains to be seen whether this is an annoying gap that lets dust in, or since my mask (3M 4251) does cover part of that lower gap, it may act as a useful extra vent, to help prevent fogging up (which can STILL occur with fully sealed goggles, even when they are described as "anti-fogging" because they have small vents built in. (There are anti-fogging sprays available which can work well; these work by creating a layer of very thin gel-like matter on the inside on the lenses, but they can reduce clarity - good for use mostly with swimmimg goggles.) I got these DeWalt goggles for £7.77, a reasonable price; they seem to be exactly the same as the Bollé PILOPSI (also £10), albeit with a different elastic band (woven-in Bollé logo) and a different (though not necessarily better) adjusting method, with a "widget" in the middle. For this price, I might take a steamer to them to open them up a bit (not the heat gun, as that will ruin the plastic's structure and thus its clarity) if the gap turns out to let dust in. On a plus note, spectacles (average sized, full acrylic frames) DO fit under them surprisingly, and perfectly comfortably. (I see some people saying they don't, but like with most things, your experience may vary).P.S: I seem to be currently the target of a moron's campaign who is indicriminately voting down my detailed reviews that I have taken time and effort to write to help you all, and frankly, it's frustrating to see nothing but the single unhelpful vote as the feedback on SO MANY of my reviews when there is nothing that can be construed as other than helpful in these critiques, so if this review has helped you, perhaps you could make your feelings known.

Nothing more and nothing less you can expect from DeWalt. It's an excellent quality product. Bought 2 pairs just in case one broke but this glasses are not easy to destroy.

They're excellent. Just ordered a case to ensure they don't get scratched unnecessarily whilst in my toolbag.Great clarity and field of vision. Very comfortable.I'll buy again for sure 👍

Very good product at a good prive

Very comfortable to wear, excellent field of view, very clear lens as if there isn't a lens in it! They do tend to develop tiny water droplets on the lenses at the very edges in high temperatures but not a problem as a quick wipe and they're brand new again.Great protection coverage and breathability. Would recommend.