SpeedOut Cobalt Damaged Screw Extractor Kit, 4 Piece Set

My screw was completely stripped, and this kit removed the screw! It took me several attempts so don’t give up too soon

Well, I followed the directions to the letter and the bolts no closer to being out. The bit is not looking good and I’m thinking about getting my Drexel tool out to cut a slot! To sum up, not a great product. Wish I could rate it higher but it just didn’t work for me.

Wollte eine Schraube rausholen, da meine Bits nicht mehr fassen konnten. Habe wie auf der Anleitung beschrieben versucht die raus zu holen. Die Schraube ist noch drin und die billig Bits gingen kaputt. Das Material ist viel zu weich und hat sich innerhalb von Sekunden stark abgenutzt.

I had absolutely zero faith that this would work, but it did.Made the mistake of overtightening and shearing off the end of a large bolt on some very expensive equipment which was a disaster. Thought I'd give this a try just in case.Drilled a small pilot hole into the bolt first to speed up the process. Then followed the instructions and gently reversed the screw out. Couldn't believe it actually worked, a relieved man! Picture shows the extracted bolt - the bolt end was originally flat from where it sheared and inside the device.

Background, I've extracted lots of broken off bolts and screws using left handed drill bits, welding nuts on broken bolts, and drilling and using easy outs. I've never seen a more worthless tool than this. It doesn't drill anything on a hex deck screw and doesn't grab anything when using the extractor side. A rubber mallet is equivalent to the effectiveness of removing screws.