HooAMI Personalised Engraved Stainless Steel Blank Stamping Tags Charm Pendants for DIY Jewelry Making

great mirror finish

These are just what I was after. Although I have not engraved on them yet I wanted to write a review as I was nearly put off from a previous review about the quality. There is a protective plastic layer that you peel back, mine arrived like the photos shown on the review and so I thought I would open it and just check, and voila, nice shiny steel! They work out about 49p each, no doubt cheaper to buy at wholesale depending on how many you do, but I like them.

I had read and seen they were small but they are very small. Much smaller than typical pet ID tags. That said they are just about big enough for what I need.The price and delivery was excellent. Can’t fault that.

Very tiny compared to what I was expecting but after reading the description again, it does actually say it’s only 10mm in diameter, so partly my fault. However, these would make nice little charms, so useful nonetheless.

I read through the other comments regarding this and was skeptical of how well it would take a stamp but I have to say that it did very well indeed. Yes, it needs a slightly heavier hammer/ hand than other blanks do but in my experience, most stainless steel blanks are that way. All in all, a good buy and value for money.

Did the job I used them for

Great for my purpose

Work well.