ArisakaOptic Leveler Small

This scope leveler is precisely made, and outstanding quality. I believe that it will last my lifetime with east.

This was so much easier than using the levels that came with my mounting kit. I didn't need a vice to rest the rifle in, nothing needed to be level. Just keep the scope ring screws loose enough to rotate the scope, then tighten them to spec when you're ready. Besides being easy to use, it's so small that the two pieces fit in the case with my torque driver. The only drawback I see is if your mounting platform isn't flat.

Works great! You can get your scope dead level on the first try. No more guessing with bubble levels on how much adjustment to the scope is needed just to get close enough to level after 10 trys. I was able to get a perfect level the fist time. Since this uses the flat botton of the scope vs leveling off of the scope turrets which are sometimes off a little you get a much more accurate leveled scope to the mount/rifle. It's not a must have but it makes things so much easier and quicker.

First, the price for this is absurd once you see what you're getting. The one I received had gouges in it. It was in a little ziplock bag and there were no marks on the bag so clearly it left the manufacturer that way. The package insert has a QR code for instructions. When you get to that webpage there is nothing resembling this tool.

I wish it came with the other wedge for use on higher mounts. But it’s very easy to use. Save time instead of using bubbles, it works well with American Defense mounts and warne mounts. I’ve read people say it doesn’t work on aero but I saw a guy use it on one you just need to slide the turrets as far up as possible in the mount and there is one flat spot for it.

Needed a general scope lever. I have a dnz nevel which works great with 1in dnz mounts however I needed a 30 mount. Sadly a dnz 30mm + a 30mm nevel was more than I wanted to send. I used the arisaka lever to level a trijicon 1-4 accupower in a warne skel g2 mount. It worked great. Only con was I couldn't butt the base up against the mount it had a slight lip. I was able to have the base sit on the scope mount flat and level the scope out. I used it on both sides to be sure before sure.It will probably work for most 1 peice bases and rings just fine.

Easy to use product that allows leveling the base of the scope with the top of the mount or rail interface within a few seconds. Highly recommend this product if your set up will allow using it.

Great devise when using with a one piece mount or any Mil-Spec 1913/Picatinny-style rail. Worked ok on a Leopold One-Piece Mark Four mount and rings on a Mark 6 3-18X44 Scope. However, the base is kind of short and the Leopold base has canted edges so the Arisaka base plate kept slipping off. I would give it 5 stars if the base plate were slightly longer, which would probably require re-engineering the angles. Used a couple of Wheeler bevels to confirm and it was spot-on.