Cordinate 10ft Floor Cord Cover, Cable Protector, Hide Extension Cords, Protect Cords, Prevent Cable Trips, Heavy Duty Cord Hider - Cable Cavity = 0.75" (W) x 0.43 " (H) - Tan

Purchased to cover a cord running from the wall to our couch that was a major tripping hassle (the only entryway we have). We needed the cord so we could plug in electronics (lamp, chargers, etc). The cord cover is heavy and stays in place. We were able to easily trim the length to make it to fit the space. No one has tripped or fallen since installing. It stays in place amazingly well and matches the color of our carpet well enough to not stand out. Purchased in 2021 and have zero complaints! Would absolutely purchase again!

We used these to run power to three foosball tables in our game room. They adhere to the floor nicely. I was nervous about using the provided double stick tape on our brand new laminate flooring. But I tested it in a small area and it seemed like it would come off easily if we ever needed to remove it. I feel like there was not enough tape provided for the length of the conduit. I do agree with other reviewer‘s comments that they curl up very easily. Upon receiving this product I took it out of the box and unrolled it and placed it next to our baseboard heat for about two weeks. It’s still remained quite curled. As others suggested I used a hairdryer to soften the material prior to adhering to our flooring and that did the trick!

I purchased this cord cover to replace an entryway mat that was covering an extension cord going to my music area.The cord came in a box coiled up, which I expected. I laid the cord cover out on a hard surface and put heavy objects on top of the court cover and let it set for 12 hours to flatten out; Which was successful and aided Installation.I laid this cord cover on top of smooth concrete. In order to prep the surface for good adhesion with the included double sided tape, I cleaned the concrete with brake parts cleaner. I also made sure the concrete was at room temperature (70°F).I noticed immediately there was not enough double sided tape to cover the length of the cord cover on both sides. If you’re unwilling to purchase additional double-sided tape, you’ll need to cut the tape into strips , about five or six inches long, to cover the length of the cord cover. I also recommend putting weighted items on top of the cord cover after the adhesive tape has been applied to the surface and allow to chemically bond to the flooring.In the end, the court cover looks a lot better than an entry mat. I had previously covering my power cords. The six foot long cover was true to length and I would probably purchase again.

First of all, the item itself looks fine visually when on the floor, you get what you see. However I had 2 big problems that hinder how helpful it is around the house. First big issue I have is the gap below for you to put your cords in is way to wide. Due to how wide it is, the cords easily slip out constantly even when using the adhesive. It would be better to make it easy to pull open, but have it fully close to keep the cords in it.This gap also has a negative effect on the adhesive itself. The adhesive has a much smaller width than the slot you place the cords in. Because of this I am unable to really place the adhesive on the product really well to where I don't either have it disconnecting from the cover, or have the cords sliding out. This would not be a big issue if they gave you more so perhaps you could put it on both sides, but it is only enough for you to tape it straight down the middle.

did what is was supposed to do. It didn't flatten out at first, i had to put heavy items on it before use but it does its job.

Does the job. Eventually lays flat and keeps cables from being a tripping hazard. A fair amount of cables can simultaneously occupy the channel inside. Has a good weight to it so you can vacuum clean right over it.

Just built a new house and forgot to have floor plugs for my living room. Works great and haven’t had any issues with it not sticking to my tile floors. Not ideal but it’s a solution

I had to get an extension cord to the other side of an area rug. This product safely does so, preventing the cord from fraying and becoming a fire hazard. Others have commented on the inability to straighten the cover, and the need to have additional tape. While I didn't use any tape I can say that by tightly winding the cover double reverse from how it came (i.e. starting at the curled end and with the bottom side up) and then leaving it like that for a day I was able to get all but the last 6 or so inches flat. I then cut that last section off and voila! Specific to use under rugs, while it solves the problem it is not perfect as it causes a hump in the rug that we managed with a coffee table and end table.