Snap in Clips for 3/4" PEX Tubing (80/bag)

I used these to hold in place some new Pex pipes I installed. Much more secure (using a screw to hold them in) than the cheap nail-in type. And they will not bend and break like the alternative.

The ad says these are for 3/4 inch PEX. I tried one on 3/4 PEX and it was loose. I could slide it from one end to the other. I put it on 3/4 inch PVC and it was a sung fit. I’m other words. Attaching these clips to a wall. Then snapping in 3/4 inch PEX - the pipe would slip through. It will not hold PEX in place. But these clips do hold 3/4 inch PVC very well.

Very easy to screw in and also very easy to snap in PEX tubing. I installed them a couple of months ago and have yet to have one fail from stress or have the PEX pop out. They also require only a single screw to install where lots of other clamps require two.I do wish the stand-off distance was a little higher to make it easy to snap pipe insulation around these. These clamps are thin enough that the pipe insulation snaps on around the clamps with virtually no problems. The only issue I have is that the stand-off distance is too small to let the pipe insulation close easily.Bottom line is that if you are installing PEX these are great clamps and very economical too.

I really like these pex tubing holders. Easy to install and more importantly easy to remove the pex line if you need to. These sure beat the other options that do not allow you to remove the pex. The pex stays put once you press it into the holders and comes out easily if you need to work on the pex.

I really like these clips. They are simple and easy to install. The only criticism I might have would be to design them with a slightly longer stem, and tapered (foil shaped) so the pipe insullation could be applied without trimming at the clips. Aside from that, these are very cost effective and simple to install.

I had been looking for something to 'space the pipes' off the joists and a screw mount design instead of hammering in a clamp, especially in tight spaces. These work very well and have the added advantage of snapping pipes in place so you can work with them easier. Also, handy for plumbing rework. The snap action could be a little stronger or better yet, a design change to allow a ty-wrap. I had to 'wire' down some of my more stubborn pipes that came out of a 50ft coil.

This clip does not tightly clip to 3/4" Apollo PEX tubing, its a better fit for 1" tubing. The advertised inner diameter should be 7/8, but as you can see in my photo the true inner diameter is 15/16.

Advertised as fitting a 3/4" pipe - obviously 1".Very lose around 3/4" pipe. Fits nice and tight on 1" pipe. They should really have measurement pics. If they did, I wouldn't have purchased. I guess that's the idea 🤔

no los compren, no sirven.