AKK A2 5.8Ghz 40CH 200mW FPV Transmitter Raceband 600TVL 1/4 Cmos Mini FPV Micro AIO Camera with Clover Antenna for FPV Drone

excelente producto, lo eh estado disfrutando bastante

I've been flying extensively with this for the past 6 months. I originally bought it because it was cheap and light, but I was amazed by the camera image and the superb cloverleaf antenna, which is good enough to make this little 200mw transmitter perform like a much more powerful device. the large FOV is also nice for FPV and the light weight and good build quality made it survive its fair share of "rough landings"the vtx does get super hot and positively needs a good airflow or it will overheat and shut down. this is not a problem in-flight but it makes bench-testing tricky as one must remember not to leave the camera on for more than a few minutes at a time. it also bit me once when i was searching for a downed airplane and the video shut down because it got too hot sitting on the ground.after 6 months of perfect operation something happened the other day. the signal is full of electrical noise and not really usable for flying anymore. everything still seems mechanically sounds so not sure what happened, but i still feel i got more than my money's worth and so took the time writing this review while ordering a new one.

This AIO cam is amazing! Going for the B3 next and looking for something with built in OSD. For this cam I mounted it on a parrot swing with an external 1S to power the cam and vtx. Results = endless fun for so cheap! Since the range on the swing is so limited I could even go with a 25mw camera but I find the 200mw transmission is good for the hard turns and penetrating trees when flying high around the yard.

Works ok, Almost 180 degree picture area which is non adjustable and the lens cannot be replaced.

Funciona bien, es prender y ya funciona, cualquier receptor la agarra, pero se debe medir bien el voltaje, la carga que consume y si se va a probar primero antes de montar en algún RC, debe de estar en un lugar ventilado o aventarle aire, se calienta mucho, en aviones y quads no tendra problema por el viento, en RC cars se calienta mucho, requieres adiconar un ventilador