GOOACTION1PC Golf 5 Pin Hole Red Replacement Putter Weight Wrench Tool/2PCS 20g Putter Weights + Putter Wrench Tool Kit Compatible with California My Girl Golo Newport Putter Club

Following an initial light hammering of the prongs into the cameron holes which seemed to set the tool perfectly aligned, itl worked as described. It's easy to use (I didn't even need to heat the putter head to help unstick the slightly glued-in original weights). It's very lightweight and seemingly well constructed, so I'm happy. Will probably not use it much; (who changes weights on one cameron putter (Kombi) that often), so it will likely spend most of its life on my golf repair shelf. Recommend

Works best on Scotty Cameron’s once you soak the putter head in boiling water to loosen up the weights

Worked perfectly. The weights need to be heated with a heat gun or hair dryer to break the factory seal. If it is too difficult to remove the weight with this tool then heat the weights more and they will turn right out with ease.

Just okay.

GOOACTION 1PC Golf 5 Pin Hole Red Replacement Putter Weight Wrench Tool works fine for the 2020 Scotty Cameron Special Select Squareback 2 putter. I had a difficult time finding this wrench (and weights) because the Scotty Cameron 2020 SPECIAL SELECT putters must be too new or something. The wrench description and even the weights were not CLEARLY delineated. Glad I took a chance. And for those that are concerned about the wrench tips bending, they should apply some sort of oil (used for rusty bolts) to the weights prior to trying to unscrew them. I always leave a small coat on the weights because they won't fall out and will always be easy to remove.

Needed to remove weights from my putter so i can refinish it. It worked very well.

This product sucks. I used it once to replace the originally weights of my Scotty cameron and one of the sprongs came out. What a joke. Not even close to the quality of hoped for.

Perfect tool for removing/securing Cameron weights. It is anodized red has some heft to it and the tungsten bits fit perfectly into the weight holes. Factory weights are locktight/glued in place so one needs to use a hot/warm blow-dryer to loosen glue first...then the weights are removable.