GASPRO29 x 13 Inch Glass Wind Guard for Rectangular Fire Pit Table, Thick and Sturdy Tempered Glass Panel with Hard Aluminum Corner Bracket & Rubber Feet, Easy to Assemble

Arrived without damage, well packed, easy to assemble only took 10 mins, you might need to open the hinges just a little with screwdrivers so the glass slides in easily. Looks great and really does do the job as a wind guard, we can now use the fire pit on a windy night! ... very happy

Very good quality

We had to carefully wiggle the corner brackets to just the right spots for them to slide in place. Once they were lined up they were very easy to tighten and overall assembly is straightforward. We really like the guard and recommend it! Glass is thick and sturdy.

Looks great and does it’s job

If you are reading this then I don't need to tell you what this does right? So let's get right to it then.The tempered glass panels are thick and free of distortions. I'd say they're about 7mm thick. This thing isn't a light weight and should hold up well outdoors.The size fit our fire pit perfectly with about an inch gap all the way around the gas tray. There are rubber feet to raise the glass about a quarter of an inch thus allowing air to feed the flames.Since glass and metal brackets don't bend, assembly can be a little tricky especially if some of the sand casted brackets a slightly out of spec. Make sure each bracket is facing the correct way, as four have threading for the feet and four do not.My recommendation is to finger tighten each screw leaving some wiggle room to get the last glass panel on. I had to use a little WD-40 to get it to slip onto place. Once it's all together, then I proceeded to tighten snugly no over do it, the screws. Install the feet and you are ready to go.

Put on our table fire place. Helps block the wind. We put a plastic lid over it sloping slightly, then the furniture cover. Otherwise, it fills up with rain.