FITUEYES Wooden Printer Stand Cart On Wheels PS304003WB

Packing was goodit's a pre assembled(including wheels)The stand is well finished, got enough space for ink tank type printers.The wheels seems barely screwed to the base if the stand be cautious when moving with a load on.Overall a decent stand for printer.

Value for money . Nice and strong

Sold by Dropship ShoppingThis is a decent stand. IT IS SMALL, very low. A printer on it will fit UNDER A TABLE.This comes shipped in a box, it is packaged very well, some wrapping in foam rubber.All holes are predrilled.I chose this for its size to hold my computer under the table and I didn't expect much,however, I was impressed with the workmanship, the holes are drilled perfectly.It includes a latch type securing device at each corner, and is stregthened with plasticdowels. It was much better construction than I expected.The sides top and bottom are made of that compressed wood, the outside coating seemslike a tough vinyl, looks very good.it has 4 wheels to easily access the printer and the storage areas.You are able to put the top divider on either side or omit it completely but it helps strengthenthe stand. The stand is very stable.Just to put it out there, because of the wheel locations, your weighted equipment needs to bein the middle of the top to keep it from tipping. The wheels are a bit inset so it will tip if you applyweight towards the edges. This is just an information thing. I have a computer sitting on them andthere is no tipping problem. I would recommend this if you need a shortcart that can fit under a table. It is strong, sturdy, built well and looks good.I do not know the seller and did not receive any money or product for my random review.210426 2138

To all of those that complained about problems of assembly, well .... stick to batteries in a flashlight.This couldn't have been easier to put together; all the parts were there and fit precisely. It helps to label all the panels prior to putting it together. This unit is strong and sturdy, and I'm sure it will last. BTW, an electric drill with a Phillips bit makes life a lot easier.A great product; thanks.

I’m giving this product five stars because I looked everywhere for an inexpensive printer cart and this was a good fit. It takes about twenty minutes to assemble, possibly shorter if you have assembled a good amount of IKEA furniture. Make sure you measure your printer...the cart is pretty small. No problems with shipping and all pieces assembled together smoothly.

This was relatively easy to assemble, but the edges are so sharp. So far I’ve sustained two injuries from this and it’s only been a day. I cut myself on an edge while assembling and then later stabbed my foot on a corner. Be warned that the edges are very sharp. I may try to sand some of them down to prevent further injury. Otherwise it’s a great piece.

Needed something cheap to hold a printer under the desk and this works great. It is made of cheap material and is fairly flimsy, but it seems to hold up well enough. We do have to roll it out when needing to scan as it is a little too tall to open the top of the printer. The storage bins are great for holding extra paper and ink cartridges.