Bayou ClassicBarbour Int'L Hose&Regultor 10 Psi 48In Stnl M5Hpr-1

Product as described, and delivered on time. Thank you.

Bought this to replace the stock propane line for my Masterbuilt Dual Fuel smoker.With the stock line, you could only change the flame level by using the knob on the front of the smoker. This caused big swings in the temperature that were difficult to correct.After some reading on various forums and such, I was directed to buy one of these replacement lines by many who had similar issues.The built in needle valve on this propane line enables me to dial down the heat further than the stock line would. I can leave this on just the point of "open" and maintain a temp between 225 and 250 with minimal effort.I will advise you though, this thing does go up to 10 PSI, so BE CAREFUL. If you turn the valve even moderately, it will turn your burner into a GIANT FLAME TORNADO OF BURNING DEATH. This valve is VERY touchy, and you need to be delicate.On this particular Masterbuilt Smoker:1.) Turn your propane tank on. 2.) On the knob of your smoker, turn it to the highest setting. 3.) On the needle valve of the propane line, turn it "open" just enough til you can hear the gas flow. 4.) Ignite with the smoker ignition.All of that being said, it's easy to install. You literally just replace whatever old line you had. It was definitely easier than trying to install a needle valve on an old line.It did the job I intended it to do, and that's all I (and my BBQ) can ask for. I'd recommend it!

update January 2020. Although my original review still stands, I am still using these regulators. I am not sure if I have just grown used to their specific idiosyncrasies or if I am just lazy and have not yet replace them. The valve is way too sensitive on these units and the hose is a little bit long, as I mentioned in my original review I am not using them for the purpose they were designed for. Your experience may be different than mine. Original review July 2017. I purchased this regulator for my Blackstone outdoor griddle. Although this does allow me to increase the size of the flames, I lose the fine control from the knobs. Also the valve on this regulator does not do a very good job of regulating volume of propane. This would probably do fine on the turkey fryer it is designed for, but anything less than full blast is hard to control. I should probably have purchased a replacement regulator for the Blackstone pizza oven for my Blackstone griddle. That regulator has a lot more control.

Seems well made and does the job. BUT... a friendly warning. I bought this to replace a hose and regulator that had gone bad on my turkey fryer. This one is 10 psi. I tried to find out what the pressure was on my old set up and couldn't find it anywhere... but now I gather it must have been only 5 psi, because when I turn this one on just a bit it roars (good!) but adjusting it is tricky -- very small turns of the knob needed to tweak the size of the flame.This is in no way a criticism of the product, which seems fine -- just a caution to make sure you buy the right pressure -- 5 psi or 10 psi -- for your own unit.Clear as mud? You bet!

Good quality, works great, just be careful to not overfeed your device. This turns your grill into something that you can sear a steak like the best restaurants. It heats to point where heat plates are glowing red in the evening in the time from when I light grill to go get the steaks to put on it. Too many grills are like cooking on a candle! This gives you control. It sounds like an f16 taking off if you crank it, but don't go too high or ever ever do it with the lid down to light it. When friends use my grill, they always MUST have one for their grill-it makes that much difference. Upgrade yours.