XCOVER Low Profile Hard Folding Truck Bed Tonneau Cover, Compatible with 2019 2020 2021 2022 2023 2024 2025 Ram 1500 6.4' New Body Only (NOT for Track System, Roll Bar & Multifunction Tailgate)

Pretty good quality for the money. Labeling the rails would be helpful (Driver/Passenger side; Front/Back). I looked at these for a long time, trying to understand how the rails (Critical Parts) should be installed. It isn't obvious and their videos don't help.End of the day.... I like the look. Secure and managable.Ran thru a car wash today; not quite water-tight but close--probably the seams in the bed liner.

If you don’t need the feature of folding flat against the cab, this is a perfect cover for $400 less than those with that feature. Even if I need the full bed, it’s two screws to take this off.Install is a breeze and takes roughly 30 minutes. Most of that was lining up the cover just right so that it would seal the tailgate but also let it open freely. One tip: don’t install the screws holding the cover to the rails until you get it all aligned.Most complaints here regarding install have been addressed (at least for my Ram 1500):-the side rails can’t be confused one side for the other, the drainage tubes only go into one side on each making it obvious which is which-the screws that hold the cover to the rails are easy to hand tighten and have a secondary wing nut to prevent looseningOverall it looks nearly identical to the top end ones, it just folds one less time. I’m happy with it.

This is a great kit. There is no point in purchasing the bak flip that's over $300 more unless you really don't want to spend the 30 seconds too unscrew two plastic nuts and just want to flip this thing up along your window. With my old soft tri-fold on my old truck I would just take it off because it only took 30 seconds to remove it with two toggle bolts, and I got the whole bed back. This one is similar. I would rather remove it and put it in my garage than block my entire rear window while driving home.So on to this product. . The fit and finish of the cover is really nice. The side gasket material is soft and I didn't need any of the peel and stick foam for the side rails since my 2019 ram 1500 doesn't have a curve to the sides of the bed rail so it fit perfect. Definitely do not tighten anything down completely until you close your tailgate to make sure everything is square and that the seal for the tailgate smooshes to keep out water.The only improvement I would make on it are on the handheld knobs that you use to tighten the cover down to the side rails towards the bed window. It is quite tedious to put on a flat washer and then a lock washer and then the large black plastic nut while making sure the gasket bolt is not spinning while you're tightening things down. They definitely should have made the gasket thru bolt square so it stays in place while you are threading on the plastic nut. Also some sort of string tether would be great so you don't lose those nuts. Honedtly, A little bit of engineering and the nuts and bolts probably could have been replaced with something more practical where you're not losing pieces and parts.Overall really nice setup though.

Fits perfect on my 2020 Ram Big Horn. Relatively easy to install. Can't wait to do spray in liner to make it complete. Highly recommend for do it yourself folks.

Installation instructions needs to be better

Good looking sturdy cover but after 1.5 years underside rusting and bubbling up. Attempted to reach company via email and no response.

On my old truck we had a soft cover, ut was ok but never really looked good. We love the look of this hard cover on our truck! It sits down lower don't leak and is more secure.