Front Driveshaft For Jeep Cherokee Wagoneer XJ Commanche MJ 4.0L Auto Trans 1987-2001 - BuyAutoParts 91-01042N NEW

Looks a little stronger then the stock shaft

Not even close to OEM.The universals are weird. Don’t know where they found them. Cup are held in with little C clips not even close to what normal universals use. Bet I can’t even replace them. Looks like the cut grooves for the clips are too small to accept anything else.The Cardigan or CV is noisy like it already has wear.Also when compared to the original Spicer it has limited movement. When rotated it will hit the yolk on the transfer case limiting the vertical up/down movement. I off road this jeep so I will test it for clearance but I bet it will bind and possibly catastrophic failure will occur.The package was send next day air which is great but totally beat up tearing the ends off. Almost lost the universal caps.Aftermarket’s have to do better. This is just cheaply made. I will put it to the flex test on Sunday.Percentage is high this will be going back.Also they drilled a hole in the pipe for the grease fitting. It will break right there.Totally disappointed with this.

98 xj aw4 part fit but are poor quality. Don't expect it to last 20k miles but it will work in a pinch. Sellers shipping is top notch(only reason its getting 4 stars) the yoke ears are welded on rather than part of the cast which is concerning but acceptable. Cardone joint has ~3 degrees less articulation than the Dana/Spicer equivalent. I would still purchase again in a pinch. Balance seems good.

Installed on my 1996 Cherokee Se 4X4. No Problems installing. No problems driving so far.

Just got this delivered tonight 112321.Very poor s/h. The box was destroyed on one end and the contents were hanging out the end. The box being taped over the end is just sad. Come on... $240 approx. and the stuffs hanging out lol.The other thing that irks me is the shaft does not look quality... at all. I mean just throwing some cheesy black paint over everything, including every seal, bearing cross, yoke clip and splined area is not cool. This just looks poor. I'm thinking like, $155 or less poor.There are absolutely zero zerk fittings in the ends on the caps, that I can see at first glance and that was in the picture for the sales info.I just pray and hope it is worth it when I go to install this week after the holiday.

Perfect fit ! Works great

does anybody know what the collapsed length is on the 36 inch front Cherokee driveshaft.

Caused a loud clunking noise that sounded like it was coming from the transfer case when in 4wd. I was changing out other parts at the time and didn't assume a brand new driveshaft would be defective. After going in circles assuming a transfer case or axle problem, I swapped the OEM shaft back in. No more clunking noise. Avoid this import part.