TotalBoat TotalProtect Epoxy Barrier Coat System (White, Quart)

I used this paint on a marine-plywood rowing boat. As an epoxy, it bonds well with wood and with scuffed coast of epoxy. This is my below-the-waterline barrier coat and I'm also using it on the interior planks of the dinghy as a waterproof primer. This paint is the consistency of mayonnaise with not much liquid in the container. You'll want an electric drill-powered paint mixer to thoroughly mix the paint and the catalyst. It rolls on thick and easy and doesn't sag but the finish is not smooth like topside paint. Use as-is to protect fiberglass boat hulls. I'll leave it as-is below the waterline but am using two coats so I can sand it smooth and fill with a primer above the waterline before applying topside paint. Also, the directions say to let the paint sit after mixing. Pot life is long so no need to hurry like you would with 5:1 epoxy.

Good, messy to work with

Used it as a primer coat for Interlux BilgeKote in the bilge of a boat while engine and outdrive was removed for rebuilding. All application surfaces were cleaned and degreased. The surfaces over which this was applied was a mix of epoxy, JB Weld, and gel coat. Areas were painted with a 4" foam roller and a 2" disposable brush. The foam roller purchased from the local home-doodle store started to crack and get limp right around the time I finished (1/2 hour later) apparently due to the chemicals in the primer attacking the foam. Primer adhered quite well to all surfaces, even the smooth areas of the gel coat which was not scuffed. This stuff just plain sticks! One quart was ample with about 6 ounces to spare for any touch-up. Epoxy mixed well with drill and mixing tool. Clean up with Xylene was painless. I have yet to apply the BilgeKote, but looking at the instructions, I expect no issues.

The product work fine, but cans are a little empty, which is a little disappointing

Bought this to protect and finish a wood and plywood cockpit for my homebuilt 'tri-yak'. Both my gen-1 and gen-2. Both used in south Florida Keys and salt water. No topcoat. Just a rugged no slip surface often covered in stinky chum and fish guts. No cracking or checking in the plywood floor. Sets up well and sandable. Guess what I'll be using for my new outdoor shooting table?

Works as it should and easy to use.

Great primer for boat hulls, etc Dries to a tough film overnight yet still easy to sand. Says you can’t apply over a 1 part paint, but I used it over dry, sanded Kilz 3 and it was fine. First gallon I purchased from Amazon. I found out the hard way Amazon paint products are not returnable so I looked around. Thats when I found Jamestown Distributors. Same pricing and delivery timing, but included a paint suit, stir stick, roller & pan, roll of tape, and tack cloth, plus’s 10% discount. Not sure of their return policy, but it can’t be worse and the rest is better. Even shipping. Amazons stuff was all dented, Jamestown’s arrived in perfect condition.

Quality epoxy paint, which has gotten hard to find at brick and mortar stores. I used it to add protection to a new propane tank located in a marine environment. I also purchased the same brand's thinner