400 Shock Pump,Silver

Couldn't be happier with this pump. Finally was able to get my rear shock set up for my weight and it makes all the difference in the world. Instructions provided are sparse, but it's pretty easy to figure out. Unscrew the red screw before screwing it on your pump. Also, make sure you extend the hose to 90 degrees, if you don't, you are going to have a lot more pumping to do.Mine didn't look like the one shown, it has a better (in my humble opinion) grip on the pumping end.

Okay...this pump is awesome. Trying to keep pressure at 300 psi when removing the pump from the valve has been a nightmare with other pumps. This one is a breeze. I picked this one because of the wider pump handle...more comfortable pushing on.

Pumping gets real tough over 300psi, but that is probably normal for that high of pressure.

very impressed with the quality and fit/finish of this pump. Works great for the rear shock where tuning can be painful. Super high pressure and allows for precise tune of the suspension.

Great pump so far. Only had it for a short time. Use for my cane creek shock and my air-zounds horn. Does not lose pressure when disconnecting.

ok pump

I don’t tend to write reviews, especially right out of the gate, but this one needed to be said. The thing is plastic. Very cheaply made, but it works, hence the three stars. Be very careful with hand placement when pumping, especially at the higher end of the 300-400psi spectrum. It takes a lot of effort and the grip isn’t quite there. So you end up snapping the gauge off with you trying to grasp the pump.Decent product, a little on the pricey side for the value, but gets the job done if patient. MFG Note: Make the head of the pump out of aluminum at least, and the gauge housing. It can work as a grip, and the business end of things intact.

The no-loss fitting on the hose works very well. Once over 300psi it gets REALLY hard to pump and it takes a LOT of work to get up to 350, but that's to be expected for such a small pump at those pressures. After using the pump several times I did manage to break it. During a session of furious pumping to reach high pressure on a rear shock the plastic bezel between the shaft and body unscrewed itself. I didn't notice this so on one of my rapid pump strokes the I snatched the shaft out of the pump and it broke part of the plastic bit that retains the sealing o-ring on the end of the shaft. Now the pump works on every 2nd or third pump as the o-ring moves around. If you have one, make sure you tighten that bexel well and check it frequently.

werkt goed

Decent shock pump to add or remove air. Not sure how accurate the gauge is though. It was a bargain as I bought this for just under £6.

Parfaite pour des fourches et des amortisseurs de vtt pas de fuite au retrait de l'embout, ne convient pas pour gonfler des pneus de vtt le débit est trop faible cela métrait trop de temps.Bon produit.

Es una bomba que hace lo que n

Esta bomba cumple con el objetivo, la uso para un rock shox monarch y no tuve problemas, hay que entender que este tipo de bombas no son para inflar muy rapido los amortiguadores, mucho menos para llantas, ya que son bombas de bajo volumen y alta presión, por tanto van a tener que bombear bastante si quieren presion arriba de los 250psi, no es una bomba hecha para uso rudo ya que trae piezas plasticas, y he leido que algunos bombean muy rapido y la rompen, dicho esto, creo esta bastante bien, tampoco se le da uso diario, cumple muy bien.