MTC 50024 Primary Clutch Puller for Arctic Cat Most 1996-09 Models 0644 207 PCP 5

what do you expect for 20 bucks....it seems to be well made and hardening seems good. i got one clutch off with it- the next clutch actually bent the tip on the puller. but it worked out good in the end- i cut the bent tip off, put the sled on its side and filled the cavity with water. then i put teflon tape on the threads of what was now essentially a bolt. screwed it in and it popped right off. overall im happy with this purchase.

Worked, no issues. May not have been 100 percent straight, or maybe I bent it a little, but worked with no issue. Tighten until you don’t dare go further, than whack the clutch with a soft faced hammer.

The nose bent and started digging into the crankshaft threads when I thought I was impacting. Did not remove clutch, and is now completely useless. Look for something made with quality steel, but pass on this one. Try the water-freezing trick, try the grease trick with a bolt, those would work better.

Was actually looking forward to rating this product/tool. DO NOT BUY IT. IT BENT THE VERY FIRTS TIME I USED IT. AND MY CLUTCH HAD BEEN OFF THREE MONTHS PRIOR. ended up tipping it on its side and filling the clutch hole with fluid and using a 9/16-18 bolt with Teflon tape like the first time(off it came)

Works Wonders! I have a 2003 - 2004 Arctic Cat ZR 800 EFI, popped the clutch off quick.

Bought for a 2007 arctic cat m7, stock sled. Greased the threads and tip. Used hammer while Torquing with a four-way wrench. Was having a hard time getting it off. Put a little bit of heat with a blow torch until clutch was warm to touch (not hot). Then it popped off with hammer under pressure. As you can see in the picture, the puller was bent after. Not sure if my clutch was that stuck or the product is poor. Removed my clutch nonetheless but need a new puller....

I give this a one star because it's suppose to work on a 2011 f8 Sno Pro clutch and it doesn't!

Got the clutch off and was able to rebuild the unit to ride again !

It worked as it should without bending or breaking under stress!