Lower your seat height WR250R WR250X lowering link (black)

I have never reviewed a product on any website, ever. This product worked so well, it literally made me want to take the time to review it. It COMPLETELY changes the bike, it makes it more comfortable to ride, easier to control, and most importantly, lowers the bike so touching the ground at stoplights is much easier. I am 5'11" and I can now practically flat foot both feet on a level surface. Whatever the other reviews say about loss in performance is probably an isolated incident, I have only noticed gains.

nice quality link for wr250r , happy

Great product and even better customer service. Fit finish and product are great. Best all is the customer service from Yamalink. Had a question called and left a voice mail thinking this may take a while as it usually does. About 4 minutes later Don from Yamalink called back he took the time to look up specs and answer all my questions.

I have not installed it yet but will when the weather changes. It appears to be made well and should work well.

I’m 5 foot ten and this plus the factory lowering ,setting sag and raising the forks about 10mm Made my 2020 wr250r much more comfortable. The instructions were top notch and even included the torque specs. Was done in less than an hour total.

When driving slow on difficult terrain, this product gave me the ability to touch the ground and keep control. This lowering link is superior to what comes on the bike and has a grease fittings, which is nice. If you just want to lower the bike from 1/2 to an 1 inch? Then this will be great addition.

Going back to stock after using this for a while. Installed easily and I adjusted the sag as instructed. I'm 185 lbs so maybe a heavier spring is required, in any case. The rear suspension just never felt right! I tried factory settings for compression and rebound damping. Also maybe some other adjustments after riding around with the link installed. I think this link would most beneficial for those who ride on the street a lot or or those who have a very short inseam (less than 30").

Getting the old pin out was a M-Fer. The unit dropped my bike less than a half inch if that. A few years earlier I had done the factory drop adjustment. It's nicely made but now I wish I had spent the money on a shaved down seat cover. I'm 5'-11" but have a 30" inseam. As I'm into my 50's now, dropping the bike on old mining roads seems to happen more often. Don't believe everything you read on the motorcycle forums.