Ender 3 Thermistor 1.5m/59inches NTC 3950 100k Thermistor Temp Sensor for Creality Ender 3，Ender 3 Pro，Ender 3 Neo，Voxelab Aquila 3D Printer 2Pin XH2.54 (Pack of 5)

I've purchased thermistors from several other sources and these ones were the best quality of the bunch. They had acceptable manufacturing, ok insulation length before the glass bead. I was hesitant because the wire gauge is somewhat thinner than some of the OE thermistors. However, they work great! No issues with them. They were slightly difficult to seperate from eachother but it was far from the mess I received from other sellers. I would reccomend this seller/brand. Used in aquilavox printer, no pid tune, worked fantastic.

This thermistors are just what I needed, seem to be good quality, it took me 10 min to install and they work just like oem product, cables are long enough for my printer and they come with the terminal plug already installed only time will tell how long they last but for the price point they are a steal.

My temp probe failed in my Ender 3 Pro. Placed an order for these temp sensors as they were for the Ender 3 Pro. When I got them they were about 8 inches too short. Not good. Had to cut 8 inches of wire off the old sensor wired and solder splice into the new wire. Pain in the butt. Then I checked the listing and saw that they come in 2 different lengths, 1m and 1.2m. The listing indicates that both lengths are for the Ender 3 Pro. Not true. If you have the Ender 3 Pro make sure you get the longer 1.2m length! Function wise they work well.

I am sure they will work just fine, but these are not shipped in separate bundles like the picture, they are all wound up into one bundle. Be careful when you unpack these - I wound up with a nasty tangle of wires that took 30 minutes to undo.Edit: To their credit, HICTOP did offer and deliver a full refund.

Addded a new one to my printer and worked again

I had the bed temp sensor go out on my Anet A8. Ordered these to replace the one thermistor. I have it working now - but there are two issuses.1. the plug doesn't fit my control board. Not a big deal. I just cut the end off the failed thermister and soldered it on.2. These won't work with the stock temp sensor on the hot end. Even though my hot end thermistor was still working, it wouldn't work with these. But, all I had to was replace both the stock hot end sensor and the stock, broken, bed sensor and now they work together.

I bought this as a replacement for my creality Ender 3 pro hot end thermistor and it is working great. I did perform the pid calibration and it hasn’t been an issue since. I would buy more if needed.

I spent 20 minutes untangling the thermistors so that was really aggravating and I feel it could have been avoided. However everything worked very well and at a great price.

Fit perfectly and works great

Consegna puntuale.Prodotto valido e perfettamente funzionante. Qualche problema in fase di montaggio per la minore lunghezza del cavo rispetto all'originale, anche se alla fine non limita i movimenti dell'estrusore.Perfettamente funzionante come termistore.

Fonctionnement identique à l'original. Parfait

Negativ1. Etwas zu kurz für einen Ender 32. Das Thermometer bricht leicht ab.Positiv1. Sehr ähnlich zum original!2. Läuft bei mir ohne Probleme :)

Solid thermistors. Works perfect in my Ender 3.