Mercury AdhesivesM300M 2oz (medium CA)

Easy to use and effective adhesive. The cap screws tightly so it likely to last a while in the bottle.

I have run the gamut of searching for the correct CA glue for adhering my 3.5" Crossbow Vanes to the extra stiff spine Carbon Bolts, They will have 202 lbs kinetic energy 608 grain- traveling at 360 fps (at 60 yards), not the Normal Bolt for everyday Crossbow hunting (most are 400-500 grain, 350-400 fps at 40 yards) I need something VERY Hard hitting for High Country Elk at possible 60+ yards, this VERY TUFF glue is "Just Right" and super easy to work with, I set my fletch in my horizontal jig, let a very small bead flow on the fletch, run a toothpick while spinning it across to remove the extra glue, press the bolt down and clip it for 2 minutes, it pulls out with no trouble AND most important, stays stuck. I allow 16-24 hours for full cure- The Very Best CA glue out there (I have 6 bottles of other brands to sell now)- I'm one Happy Backwoodsman !!

I have not had this long, but it seems to work well. It has a nice long nozzle which makes it easy to apply. The viscosity makes it easy to apply as well. Since it declares that it won't dry up, that will be the best thing. Only time will tell.

This is my new favorite glue! in comes in 2 or 3 different “strengths.” I choose mediam for broken ceramic and Christmas decoration. It went on well on adhered within seconds! The bottle tip doesn’t get glued together after 7-8 uses, so I don’t have to dig out the opening with a nail or pin.

I have used many different CA glued over my 45 plus years of building RC models and found Mercury the best. Love the top with the pin inside, keeps tip from clogging. I have in the past had a bottle harden, contacted Mercury and they replaced it at no charge.

Took me about two years to finish bottle. No clogging and glue was good to the end. Best super glue I have used.

Used to bond Blazer vane fletching to carbon arrow shafts. Worked very well. The viscosity of the CA was toward the low side (not as low as water, but not as thick as maple syrup), but seemed to say in place and no gaps resulted between the fletches and the shaft. In general, a good product with hopefully the shelf life that they advertise.

Used on wood and balsa models worked great