EK Water Blocks EK-Quantum Torque 6-Pack Raccords

EK makes some expensive fittings, but it's one of the few times the cost is justified in my opinion. The grip when the collar is cinched down all the way is reassuring and getting them torqued down all the way can easily be done by hand because they are textured in a way that won't cut your finger and thumb pads to spreads, and they are a decent size to actually get a good grip on.Biggest issue you might have with these is that they require a bit of clearance so maybe not for a SFF build.

This fittings is for soft tube 5/8 OD. You may want to check the OD to make sure your block have enough space for 5/8 OD. My GTX-680 water block connection opening is too close to the GPU card. I could not tighten g 1/4 since the edge of GTX-680 card is in the way. I don't want to use my drill to cut my GPU board. I end up switching both connection opening to the bottom where there's no obstacles. The caveat is that when two openings are on the same side, you may need to make sure the routing of the pipe won't pose problems. In my case, I have the challenge of hand tight one of the connection.

These are high quality fittings. Keep your eyes open for the box of six in EK packaging when doing your build. It’s a much better deal than the pack of four you normally find, and you’re probably going to need at least ten of them anyway, depending on whether or not you’re cooling both the CPU and GPU. Highly recommend.

Cumple con mis expectativas. Vendedor muy cumplido y a tiempo con la entrega

Solid products. All around.

happy customer

The product is the same as described, fast delivery.

The items have wear on the turning knobs, the there are small indents and chips on the male inserts. I'm only keeping these because I need them, but in the future I will only order from EK directly. EK was out of stock at the time.

lo que no me gusto que no tubieran en existencia el EKWB EK-Quantum Torque STC-10/16 - Accesorio de compresión para tubos blandos, 10/16 mm (3/8" ID, 5/8" OD), níquel negro, paquete de 6 ya que necesitaba uno mas

Pretty good, solid quality but nothing special. Would say a little to expensive for what you get.

El modelo actual es mas grande que los anteriores, son mas faciles de apretar y parecen mas resistentes.

Abgesehen von Preis der bei ca 38-45€ (manche Shops wollen 50€) sind es neben den Alphacool eiszapfen und den Alphacool OEM fittinge die besten die ich je verbaut habe . Obwohl mir die alten fittinge von ek etwas besser gefallen muss ich sagen das die alten nicht mit jeden soft Tube nutzbar waren . Diese hier schon .Habe 4 unterschiedliche Schlauch Arten die einwandfrei harmonieren .(EK Schlauch , Alphacool Schlauch und masterkleer sowie mayhems )Ich bin zu Frieden .Allerdings könnte langsam mal EK von dem hohen Ross runter kommen was Preise angeht . Immerhin hat die Qualität den letzten Jahren abgenommen !Fittinge nicht unbedingt . Aber die kühler , Radiatoren und distroplates !

Très bon fittings pour du watercooling, le look est très sobre et jolie, prix un peu excessif mais bon c'est du EK.