ActronBosch SP0F000013 Fuel Level Sender

I have to laugh at those that give universal sending units a bad review. Of course universal means you might have to do some modifications according to the tank. This unit is replacing a sending unit in my 1985 Mack MS250P Mid Liner, with a 75 gallon tank and 1 million miles. It was almost perfect, and after some adjustments, it is perfect. I really don't care about the in between calibration. I wanted to know when it was full and when it was empty. A mechanically fuel injected diesel run out of fuel is a lot of trouble. Mechanical fuel injectors do not pump air worth two cents. Every one knows that.This sending unit is the answer, especially when the part is obsolete. Its perfect. Anyone that cannot modify the install needs to hire it done.There you go. Great product and the price is right.S

I have been driving around in a 1971 W200 dodge truck with no fuel gage, it gets horrendous fuel mileage and was driving me crazy, I just found a 29gal marine tank and installed it today. The flange fit the tank perfectly, it takes a bit of finagling to get the float in, but the instructions where very clear for installation and the adjustments needed to fit your particular tank. I spent considerable time prepping the tank and where it was located. The gage ( I purchased the Bosch one) will not work with just the sender alone hooked up you have too and should ground the tank ( I ran mine to the frame) Im so stoked to have an accurate level of measurement in the old girl.

Replaced the sender in my MF285.Not 5 stars because of a slight inaccuracy.

The product is very easy to adapt and modify. The chart that comes in the instructions give clear and specific measurements to trim the critical parts down to for any given tank depth in the ranges this sender was meant to satisfy. This is a very easy sender to install. Anyone leaving negative reviews saying it doesnt fit either has a deeper tank or is not mechanically inclined enough to understand how to trim a bracket or adjust a rod length and tighten set screws. Great value and a great product. I am happy with it.

Product worked fine for a few weeks, however stopped working. Found out the float arm fell off into tank. Whether it's install error or not, took time to get a replacement part that I would gladly pay for I was told to contact Amazon. Website gives manufacturer info. Soo who knows. Thanks.

This will work perfectly on my project.

Installed this in an older skid loader. Worked fine for minutes then no reading. Pulled it back out to find the weld holding the float arm had broken. There's barely a spec of fused material. Now I'm stuck with a float arm in the tank I cannot retrieve through the two inch hole. Otherwise it appears to be quality piece at a great price. Hoping it was a one off flaw.

Worked about a week then stopped. That means the wiring is fine. Checked gauge with another unit. Not the gauge.