5pcs 1/4” Shank Round Over Router Bit Roundover Edging Router Bit Set (1/8”, 3/16”, 1/4”, 5/16”, 1/2” Radius)

These did the job at hand wth no problems and stayed sharp throughout. What I would say to warn others, especially if the wood is quite absosbant, is to use it first on some scrap wood. When you first use them the grease from the bearing sprays all over the wood you are cutting and then needs cleaned off with solvent or sanded down. Found this out the hard way. After a few uses the grease stops spraying off it and you get a nice clean finish.

These are a good range of sizes at a reasonable price. They cut well when new but not sure how long they will keep their edge. As an occasional user they seem to be more than adequate. The bearings supplied are a different matter. Some are ok, but others are terrible. They are sloppy and dry with no lubrication. As the bearings are the same size it’s not a deal breaker as you can just swap the good ones around the different cutters. It wouldn’t stop me from buying them or recommending them as most cheap tools like this are made to a budget so small issue tend to be expected now and again.

My last 1/2" round over bit cost 3 times what this whole set cost but I needed one for the next day and my normal woodworking supplier would take 2 days and charged MORE for extra postage than this SET cost. So put the largest one in (the only one I actually needed) and ran in along the edges of the valve amplifier enclosure I was building.... Wow it just cut as well as the one I had. I can't comment on it's longevity but It made light work of the 3/4" marine ply leaving good clean cuts. No grabbing or digging in. Very happy.

These are just what I needed. A whole set for not a lot of money so I can assess what sizes will suit my projects. They work well and seem nicely made. As to longevity we will see but that is not super important for my amateur attempts. They came in a small cardboard box containing a plastic box for each bit. This is perfectly adequate but a selection box would have been better for storage but no doubt added to the cost.

On using first bit bearing exploded after the first pass tried bearing from another bit same thing happened after third pass didn't try any more to dangerous these were purchased for a one off job but didn't even do that have ordered a better quality bit which is about double the price of the five, but at least it will last a lot longer, true saying you only get what you pay for. Cliffb.

Ok for price. Wouldn’t use them where I would need perfection like fine finish furniture.

These are very good value and are better than other budget bits I've used in the past. Not sure they will last that long but I don't use them often.

A nice set of rounding-over cutters covering a range of sizes, which gives me multiple options. Inside a cardboard box, each cutter comes in its own nylon/plastic case which will protect it from damage, and is labelled with the size - very usedful. I've only used one so far, but happy with the finish.