Mira Jump MK2, Go MK4, Elite QT, Meta Shower Solenoid Coil Only - 1788.434

100% recommended seller and item. Worked perfectly when installed and I now have a working shower! Easy to install with guidance from YouTube.

Perfect, shower work great again.

Perfect part, just what I needed to fix our non working shower, the instructions were spot on and the part was relatively easy to fit, I will buy from the seller again if and when needed.

The solenoid coil is the most frequent unit that require replacement when the electric shower such as Mira Jump MK2, stops working i.e. no water flowing out. I followed youtube to replace and install this solenoid coil.

Needed this for my micra shower. Great replacement and easy fitting thanks to you tube video. A lot cheaper than paying the plumber.

Worked perfectly to repair Mira Jump Mk2 shower in UK.Remember to turn off electricity and water before removing any covers. Once it’s working, run shower briefly, then turn off the electricity again, remove shower cover again and closely inspect for any new leaks.Getting the old broken one off on this shower was a pain due to spring clip holding circular inner of solenoid so that it would not simply pull off - as most YouTube etc videos suggest it should. Eventually came off by using snip nosed pliers AND two small screwdrivers all at the same time to squeeze the four parts of the clip at the end - whilst pulling the solenoid. However, the this only allowed the old (broken / open circuit) solenoid to pull half way off before being caught by the internal ring. To get past this one was even tougher. I carefully took the metal frame off the end of the old solenoid whilst it was still jammed in the shower - bending up the metal parts to release it. This allowed sufficient access (and loosened things) to fully prize off the old solenoid. It then took less than five minutes to install the new one.Excellent seller and perfect product.

Mira Jump shower, died after 3 years with no water output at all. Simple fix thanks to Google & YouTube vids claiming it's a common issue with Solenoid failure. 5 minute fix, perfect.

I had an issue with my shower where no water was coming out when the power was on. I looked online and it was suggested that I start with replacing the solenoid coil. I replaced it but the issue remained much to my frustration. Long story short it was the isolation switch that caused the issue! However I was very thankful for the fast delivery of the solenoid coil and the installation instructions were very informative and helpful for my first attempt at fixing a faulty electric shower. Although it wasn’t the solenoid coil that was causing the fault, after replacing it for a brand new one I can rest assured I will have no solenoid coil issues in the near future!