Dynasty 4" Spring Door Hinge, 5/8" Radius, Satin Nickel, 2-Pack

I installed these on my door to the garage because my wife didn't like all of the noise (washer, dryer, AC, etc...) and smells that came from the garage (previous owner used it to work on motorcycles and it needs a really good scrubbing). Originally I had tried one of the hinge pin closers because there was a broken one installed on the door when we moved in, but the replacement wasn't strong enough and couldn't move the metal door. I bought this 2 pack expecting to need both but I only needed one and I didn't need to adjust it anywhere close to the tension that was on the hinge ping closer. It doesn't close the door perfectly because the door needs a good push/pull to latch closed, but it closes it enough to make my wife happy and so that I'm not air conditioning the garage. I spent way more time than I wanted to researching how to get my door to close on it's own, this was hands down the easiest method and it worked nearly perfect (if I fix the door latch alignment it will probably be perfect).

I came on here to see what type of hinges I ordered a while back, to share with a friend. Then I realized, I ordered 10 years ago?!?!! Five stars for never failing, working perfectly, and no need for replacement. My DOORS are falling apart but the hinges are going strong!

Good replacement hinges for the back door. Kids keep leaving it ajar and the dogs could get out. I installed these in about 10 minutes and the door shuts itself now. No issues with the install, and the adjustments are easy to make. I have it set pretty tightly as the door is heavy. If your door was lighter, these could probably slam the door pretty hard and maybe catch a finger. Be careful to adjust them as needed. Hardware included was a little short, so I used 3 inch deck screws to install in our back door. No problems and reliable service ever since.

I installed two of these hinges on my garage entry door after the old ones gave out. They fit perfectly and included all the hardware needed to ensure proper installation. The adjustment of the hinges is a little tricky, as the pin that holds the position doesn't always want to fully insert easily. Once adjusted though, the door works as intended. I took one star off for the pin issue and the somewhat terrible instructions. The concept is easy enough though, so you should be able to figure it out on your own.

I have these on a couple of my doors now. I went with 3 on each, but I likely could have gotten away with the pair as they close very strongly. That, of course, is adjustable. I am an overkill kind of guy. These have no trouble making sure the doors close all the way for my Yale Locks to lock them. We're in Florida so the humidity causes the frames to swell. Not having a visible closer was the only way to get it past the wife. I was just tired of having the doors left open so many times letting the mosquitos in or the dog out.. They feel really sturdy, well designed and I hope they'll not rust anytime soon. The weather is tough here. If they do I'll post photos when that happens..

I live in a rural setting on 24 acres. When my dog needs to go outside, I leave the door cracked slightly open. She knows to push on the door to open it when she wants to come in but I haven't trained her to close the door behind her. These Dynasty Hardware 4" x 4" Mortise Spring Hinges solve that problem. She pushes the door open and these hinges swing the door closed hard enough to latch. Problem solved. Feature wise, these hinges are heavy duty, of good quality construction, adjustable strength (I have mine maxed out), match my other hinges well, and are reasonably priced. They handle a rather large and heavy french door. I would purchase them again.

I tried installing hinges from two different box stores and neither was working. I am in a tight area and the box store hinges only have 4 settings meaning you have to use a quarter turn for each setting. These have 8 settings. They also come with the standard allen wrench but also a 4" needle style pin that can be used. The pins used for locking the spring into place are also made of iron. The box store hinges had aluminum pins. I don't think they would stand up under the pressure setting I need for a steel door. The box store hinges were also much more expensive at $16.00 - $19.00 each. You see what you pay for two of them here. I also read where someone was concerned about getting two hinges in the pack and only needing one. BAD CHOICE. You do need two. One on the top hinge and one on the bottom. If you put all of the stress of the hinge in one place you not only over use the hinge, but also run the risk of stripping our the screws in the casing. When you use two or three as I did since my steel door goes to the garage, the tension is more evenly distributed on the casing. I have 12 screws (4 on each hinge) holding against the casing, not 4 all in one spot.

We live about 3 blocks from a sheep farm, so as you can imagine we get flies. We bought fly traps and sticky paper but they just kept coming. I finally thought of spring loaded hinges for our back door and it has made a world of difference. I have an 8 ft door so I bought and installed 2 hinges. I put one on top and one on bottom. I left the middle two alone. The door closed smooth and soft. It latches as long as it is opened more than 1 foot. The screws it came with were slightly wider than my original hinge screws so they fit snug into used screw holes. I thought it was perfect in every way!

I used these on my attached garage door. The door had a small change that would close the door shut to prevent fumes from a running car in the garage from entering the house. When the chain broke we thought we might need to replace our door because yo replace the chain which went into the door was impossible. Thought we would try something like this first. First of all the hinges are very good quality and it comes with various size screws to secure the hinges. There are two in the box but my door has 3 hinges. Not a problem, just replaced the up and lower ones with these. I made sure to order the same size hinges that are on the door, making the replacement very easy. Once they were one, just adjust the hinge with the included Alan wrench until the door closes with the proper force. Great product and it works perfectly!

This Hing is too simple to install on the door, I put it on my outside garage door as u can see in the video attached. It’s very smooth, and does its job, as u see in the video, I put three hinges on that door, and I adjusted it till 5 holes not 4, if u put the pin in the hole # 4, u won’t get that force of closure u saw in the video. So u need to put the pin in the hole # 5. Price wise, I gave it 2 stars as it is so expensive for $34. Otherwise I am happy with it, it’s only 2 weeks of use, and I will update of any new situation.

Works as advertised.

After 11 years, our original spring hinges were getting increasingly noisy and were not easy to maintain and lubricate. It was worth the cost of replacement. Hinges fit exactly like the original ones. You might consider buying longer mounting screws but that shouldn't be necessary if your frame is intact and you use all 4 screw holes. Before installing, take advantage of the access to lubricate the heck of these things. Chances are they will last that much longer before they start to squeak and wear down.

High Quality Replacement Spring Hinge.