CHOLMA Baby Formula Maker 1-11 Consistency Instant Heat Pro Advanced Formula Dispenser, Make Bottle in 8s Quiet Operation Panel 1-10oz Water Range & 98-131°F-2019 Version

I love that it can take only 8-10 seconds before you have a warm bottle. With more than 6oz-7oz of formula, the warmest setting of 131 degrees heats it just warm enough. The cleaning process sounds like a lot but trust me, you'll likely include it in your evening routine and you will become faster at it over time. The only complaint is the spout on the bottom of the funnel. Sometimes the straining notches kept causing the hole to plug and it would spill out everywhere. With some slight modification by removing the straining notches in the funnel tip (with a dremel) we haven't had a clog since. Easy to use after playing around with it. Highly recommend for those fussy nighttime feedings.

I was excited because this machine had really good reviews. However I find I have to lift out the whole powder piece and unclog it (at the bottom where it dispenses) after every single bottle. In addition, if I don’t take out the little plastic piece under the powder and rinse that off after every single bottle, it clogs. I shouldn’t have to take apart the machine and clean it after every single bottle. I’m not saving myself any time doing that.I’m guessing part of the problem is the consistency of the formula, I am using the Enfamil Prosobee. It honestly would be helpful to have a guide to say, “hey it doesn’t work well with this type of formula…”Am now beginning the steps to attempt to return the machine. Wish me luck.

After three years and two babies my baby brezza finally died, so I tried this machine (based on the excellent ratings). This machine only worked properly the first time I used it. All subsequent uses resulted in watered down formula and incorrect volumes. I used all the resources available on the website to attempt to recalibrate the machine to no avail. It is also very important to note that you need a food scale to calibrate the correct concentration of formula (there is no formula concentration guide available anywhere).I ended up going back to the baby brezza. A few bucks more but it doesn’t require a PhD to assemble properly and calibrate, it always dispenses the correct volume and concentration, and it doesn’t “make” a bottle without the funnel in place (resulting in a very wet countertop). All that being said, they did give a very prompt refund which is certainly appreciated.

You don’t want to risk your baby with this stupid technology product, good idea , bad product, stuck every 2operations , sometimes supply half of the water that you need.Simply dangerous and not work well and Simone need to stop them of selling it before they will damage baby ,I can’t return it because I brought it with friend from the state but the place of this product is the garbage. It’s took me 24 hrs and almost a box of formula to realize that this product is failing. One so avoid!

6 seconds...my Daughter-in-Law excitingly said as she prepared my Granddaughter’s first “finally home” bottle and as she put it “not 1 bubble”

The heaven sent to us! No more warming up the milk for how many minutes. You just need to have the right settings.

I like the accuracy of the water measurements, and the speed of the maker when heating the water. I would NOT buy again though only because of the wasted formula from the amount of build up after each and every bottle. It looks like at least on full scoop of formula is left behind from entirely too much build up. I understand you have clean the equipment, but it shouldnt be after every single bottle. I might as well do the bottles by hand because of the mess it leaves behind. Also it has not been reliable. It has been very finicky lately. I would NOT recommend this make to a friend or buy again. Its a NO for me and this maker.