APT, 1 mil Thick Polyimide Adhesive Tape, high Temperature and Heat Tape, for Masking, Soldering, Electrical, 3D printer Application. (2"(51mm) x 33m)

Very good tape

I like this heat resistant tape especially because it is really good with high temperatures. I had a job to remove some solder from a board but needed to protect the components around it. It required me to use a heat gun at close range so it would melt the high resistant solder quickly. This tape was excellent and did an amazing job at keeping the other components safe!

OK for non-demanding applications, but this tape is not as mechanically strong, and the adhesive is not as uniform, as in the original DuPont/RS Hughes Kapton brand. I use it for taping protective plastic sheets to the floor, for non-demanding HVAC work (ducts and adapters). since it leaves no residue, is stronger than aluminum tape, and does not have a smell.

Used this to protect a latex mould as i wanted to go over the latex a with a 3D pen.This worked really well and protected the latex from the heat of the pen.overall i am very satisfied.

I use this to protect the back of a motherboard in a printer, on a heated bed, under the clips (CR6 SE) without any issue. I also use it so some higher temperature applications. The adhesive seems good and it does seem to have the correct heat resistant.

I paid a lot of money for this item thinking it would be good , i was using it to put on my 3d printer bed but it is very hard to unroll infact that hard to unroll the tape deforms so it wont go on the printer bed straight so give this a wide birth . Ive no use for this tape now so i just use it for packaging and wrapping boxes i think the problem is its very very old tape or has been left in the sun or in a very cold room hence the problem

I’ve used this in a couple of electronics projects and it’s great for insulating the underside of boards or protecting components while I’m soldering

Perfect battery wrap, nice thickness and insulation, would recommend 👌