Red Billet Aluminum Anodized Door Handle Sets Fit for Can-Am Maverick X3 17-23

Good clean look and works great once installed, makes door opening the way it should have been from the factory. Some minor trimming of plastic panel need to make it work. There are no any instructions with it so if you look online you can find pics of how it's set up and just make yours look like that. I had mine on in about 35 min, 20 or 25 was on the first one cause I was going slow and making sure I didn't take more off the panel when trimming. Very much like the finished result, when you walk up to machine just place hand on front edge of the door and handle is perfectly placed to open, works great for opening door when it's loaded on the trailer, don't have to climb up on trailer and try to find that stupid little strap that came from the factory

I’m only giving this 4 stars because of the lack of instructions but with some patience and common sense you can figure it out. Make sure that you use red locktite on the bolts and as you can see in the middle picture this is all of the plastic that you need to cut. I did it with tin snips and I flipped the factory spring over for a better fit. They feel quite sturdy and are a great fit. It took about 45 minutes for the first handle and 20 minutes for the second.

Easy to assemble once you figure out what goes where 1st door took 40 min 2nd door to 10 min

we lost a bolt the first time out and I was unable to open my door had to crawl out the window. So we pop rivet it and it works great now they are great quality and much better then what can on the door.

You get what is listed but once you open the package you realize it uses springs that are not included. Now I must buy an assorted spring kit to fix. Also where the arm attaches to the handle you must put your own small washer there to allow free movement. Use loc-tite so you don't tighten them too much preventing free movement.

The aluminum handle is great the hardware is fairly sloppy in my opinion. Bolts keep working loose

What can-am should have done instead of pull straps. Easy to install and look great. A definite must.

I found instructions thanks to another review - they're not in the package. This seems to be a good idea that just went wrong. Springs are shown in the instructions, but none are NOT included. Door opens ok from the outside, but from the inside there's just not much leverage - needs to be pushed up with a thumb and it takes a fair amount of force. I do not recommend at all. Straps actually work better.