Question 1

Is it easy to use ? And worth the money?

Accepted Answer

Complicated answer:  It's easy to use once you figure it out.  The manual is poorly written, I suspect not by a native English speaker and a little hard to figure out how to set up.  Also, the screen shots of the software don't match the actual software, so you have to figure out what they mean.  It makes really good quality prints, but here's the BIG problem:  First, you can't print PLA with it as the print head won't feed it.  I have 2 printers and both have the exact same problem.  Second (and worst part), the feed gear inside the print head is very sensitive and after ABS has been open for a while, it won't feed anymore and prints fail.  Neither of my printers will work at all anymore.  I can't get support to get the printer head fixed.  I even talked to the manufacturer at CES and they just said "oh well."  I wouldn't waste my money again if I had it to do over.  I might spend some time re-engineering the print head, but that will be a big project and a lot of trial and error.

Question 2

hi my name is david.i am jeweler.
can i make mold for rings and charms?

Accepted Answer

David,With this printer, you can make some quite ornate items. Making a mold for anything wouldn't be too difficult, but you would need quite a bit of knowledge in 3D modeling, if you were planning on designing a ring from scratch. If you already had a ring in mind to make a copy of, you could use a 3D scanner to create a digital copy. Once you have your 3D ring file, you can print it. Once you have your duplicate, you can then make a mold around that out of plaster or whatever else you were needing.

Question 3

the table only heats up to 60 degrees so the prints keep sliding off. On the into video i see it up to 100 degrees. how can I fix this?

Accepted Answer

Always use a raft. Preheat your bed. While you are doing this, blow a hair dryer on the bed also. The dryer helps the bed reach a higher temperature. Once at the higher temp, the heating element on the bed seems to be able to maintain the higher temperature. Also, after you get the bed warmed up, make sure you keep the door closed to hold in as much heat as possible. I've never had a print fail to stick to the bed using this method. Hope it helps!

Question 4

Is there some software that goes with it, and can you design your own 3d print?

Accepted Answer

The printer comes with software that can be downloaded from their website and loaded onto your computer. You can use free 3d modeling software to create your own prints. One such is Google Sketchup and there are many more. A good site to look at for print files is www.thingiverse.com where there is over 200,000 objects available. I have been having a lot of fun using my printer and so far no troubles.

About Us

Customer Services

Customer Support

Regional Access

Legal & Policies

Social

Get the App

UP! Mini Fully Assembled 3D Printer, 4.75" x 4.75" x 4.75" Maximum Build Dimensions, 0.20-mm Maximum Resolution, 1.75-mm ABS, PLA

Details

Description

Have a Question? See What Others Asked

Common Questions