Koolance BKT-PCI-G Computer L-Bracket (Double Panel-Mount) G 1/4 BSPP Threads

Review:This product is perfect for making an exterior liquid cooling pass-through look really clean. Everything seals and I found this product to be a perfect fit for my exterior liquid cooling system. I posted 2 pictures I took while I was testing for leaks. I will buy this product again if I need an exterior pass-through.Installation instructions:It is absolutely important that this product stays clean as it comes to you in the Box before you install it. The G 1/4 fittings that are female on both sides of this product also screw into each other and have their own seal. I Unscrewed both of them so I had the plate alone without any fitting. I installed the plate into the PCI-E slot. Then I screwed the G1/4 female to female fittings back onto the PCI-E plate. Then I cut all four of my 10/13mm soft tubbing to length. Next I put the collars from two of my G1/4 male fittings over the tubbing inside my case. Next I screwed my male fittings onto the female G1/4 ports inside the case. I had to hold the outside G1/4 female port still so I could get it finger tight. If you don't it will rotate while you try and tighten your male fitting. This is normal. Once that is finger tight on both inside G1/4 fittings slide the collars down and screw them on finger tight while holding the female port so it doesn't spin and do this until there is no gap between the collar and the base of your fitting. Repeat this process with the exterior fittings. The only difference is you will hold the collar of your interior male fitting while you tighten your exterior male fittings. When you are tightening your exterior collars to your G1/4 male fittings hold the interior G1/4 male fitting collar so it doesn't rotate. This will tighten all of the parts that screw into each other on all the fittings at the same time. Make sure to gradually increase the pressure until there are no gaps and no parts move independently (you dont want to over tighten any of these fittings. Be sure to run your pump for about 2 hours with paper towels under your interior fittings without the power cord plugged into your pc. If you have no leaks then plug you power cord into your pc and enjoy.

It is a decent enough pci passthrough for g1/4 fittings. The ports are pretty close together so plan on using barb fittings or very very small compression fittings.

Turned up bent. Hammered back into approximate shape, threw away after other items came back in stock.

Good if you want to add external radiators without having to drill holes in your case, however I do wish they were a bit more separated so you can fit bigger diameter fittings.

Solid product, connections work as intended. It's nice to have the pass through for cabling!! The connections will rotate in the bracket a little but not a problem. Works great when paired with some quick disconnects like I have for an external radiator.

I have not installed yet but looks well made with double o rings in each fitting. I only wish I could adjust the length like the Koolance CNT-VDA2 Dual VID Connector, Adjustable 1 Slot Spacing. That and I wish they came in gold, but other than that I love this thing.