EASTRANS 1/2" ID x 25ft High Pressure Braided Tubing Clear Vinyl Hose

Product it made very well. Would goodbye again.

I had a leak in my outdoor bathroom that I couldn’t get to, so I ran this from the spigot to get water. A section of it has been exposed to the sun since December 2020. Still no issues. Great product!

This stuff is hard to find in the store, reasonably priced

This was purchased to add to a hand fuel bulb for pumping gasoline and it works well for my temporary usage.

New washer drain hose was too short to fully reach outlet (hose connects to washer on rear left back panel), 1" drain tube only 4 1/2 ft. I found a video online that discussed creating an extension using high-pressure tubing. This tubing was unavailable/sold out at Lowe's in a 3/4" Outer Diameter (slides into 1" hose). It was difficult to advance the hose inside the 1" drain hose, but kept trying until this piece (measured, cut to advance into the coiled part) was far enough inside the drain hose. Still, it wanted to leak a bit where it dips into the outlet, so put 2 C-clamps (with screws) around the drain hose. I ran a trial several times, not quite filling the washer and using the 'Cancel' button to hasten draining. I also wrapped a kitchen hand towel around the discharge outlet. So far, so good! Tubing does not collapse while washer drains, like the un-braided I tried first. This high-pressure reinforced tubing made all the difference in keeping this washer. Probably is good for other plumbing issues.

I bought this hose for my custom cooling system for my PC. In that application, there is almost no pressure, probably less than 10PSI. So, I didn't really need pressure hose, but I think the embedded braiding enhances the appearance of the hose in my system. As an added bonus, the actual dimension were absolutely perfect for the compression fittings I am using. The OD, ID, and actual thickness are such that the hose fits over the barb snugly but not so snug as to require a lot of force to be seated. Then, the outer wall is such that it fit the compression ring perfectly. The net result is that I was able to tighten down the compression collar fully with only moderate force, forming a leak free joint with little effort. Quick tip: If you have some sort of barb you need to fit this hose over and it is just a little too snug, you can soak the end in 180F water for a bit and then apply the hose to the barb and then the compression ring to the hose-barb assembly. I have had to do this in the past in similar situations, but this time the match between fitting and hose was as perfect as perfect can be. If you are also trying this sort of application and are curious about the fitting, I used "Barrow G1/4" to 1/2" ID, 3/4" OD Compression Fitting for Soft Tubing, Silver Shiny" fittings. I feel I should leave my exact hose dimensions here for other people with tight tolerances, but I can't find my darn digital calipers. If they should turn up, I will edit this review with that info; I figure someone is going to want to know that. I hope this helps and thanks for reading.

Worked as I needed for commercial pressure washing setup.

Really great quality. Very flexible. Used for potable water in camping application. At 200 PSI it does withstand extreme weather longer than standard garden hose.

Just received, One word Value For Money

Good quality and worked

OK quality

Great quality and perfect fit on our canablast sandblast cabinet. Much less expensive than the local auto parts store.

great price