Norrec Industries Universal Boot Clamp Kit 92091-250

Worked well to seal up a new CV boot. The small tool worked very well in a tight place to get the clamp tight. They seem to be good quality stainless steel.I used it on a front inner CV boot on a 2007 Subaru Impreza. The factory clamp snapped when I tried to put it back on. That is why I purchased these. The small clamps were a little too short, but the long ones were about 6 inches long. It was no problem and I just cut off the excess. The width was perfect to fit in the groove on the boot. I only have about 500 miles on the new boot and clamp, but so far there are no leaks.

Great kit, worked fine. Instructions are kinda hard to see on the paperwork since its been copied like a hundred times over. The way to turn the screw for tightening they give you and how to "twist" to lock it is hard to understand.

Worked great on my can am after factory boot for cv joint was ripped off due to no clearance between swing arm and raised part of clamp these got the job done

These bands are way beefier than the ones that came with my CV boot. I expect them to hold really well. Including the hex tool was a nice convenient touch.

works like its suppose to.

Worked well,messed up 2 winding wrong way.Finally got it right,worked great.once I got the hang of it,it was a easy fix.

Little tough to get completely sealed with little tool.

Very hard to use I wasn't able to secure boot properly even with tool provided