OBD2 chip box is a device, which operates within power limits (reserves) left by the manufacturer. The device increases mostly torque and acceleration.ELIMINATING TURBO LAGYou'll get rid of jerking notion while changing gears, and you will feel smooter and better acceleration when adding gas.ChipPower OBD2 vs. Remapping - You car can be restored to the factory settings via disconnecting the device. - You can use OBD in every car with the same fuel type. - You don't need to finde a Garage, the instalaltion is easy. Thank to Plug and Play System installation takes up to 5 minutes! - 3D map stored in flash memory. Disconnecting the device for a short time does not causes imidate deleting of all the settings. - Much cheaper than chiptuning. You don't need to pay your Mechanick for installation! - OBD2 can be used in a warranty or leasing car. Does not causes constant changes in your engine.OBD2 chip box vs. Chip Box: - Installed in a driver cabin, without opening the hood. You can keep your hands clean. - Fully digital (processor 2oMhz). - Fast mounting and dismounting wihtout need of getting off from your car.Installation1. Connect plug connector to the OBD2 v3.0 device. Connect the 16-pin OBD2 v3.0 Chip Box connector to the car's diagnostic port.2. The correct connection must be indicated, including the LEDs on the Chip module. LED signaling may vary depending on the car brand. Insert the key in the ignition and turn it to the ON / AAC position, but do not start the engine yet.3. Now press and hold the reset button for about 5 seconds. Located at the top of the circuit board. After releasing the button, wait about 30-60 seconds for the Chip module to establish stable communication with the ECU. Start the engine.
Trustpilot
2 months ago
1 day ago
