1 Inch Fan Spacer Kit, Fan Spacer (14548), Car Parts, Silver

This was the exact spacer needed for a Jeep Grand Cherokee with 4.7L V8. I used a Flex-a-Lite 1518 Fan with an 851 adapter and this spacer for a perfect fit. Very easy installation using a rental fan clutch removal tool and a 12" adjustable wrench to remove the fan clutch. I did not follow the instructions per the manufacturer. It says to install the adapter and then the spacer then the fan. The bolts with the spacer are the exact length for the installation so I attached the fan, spacer, and bolts to the adapter and torqued the bolts per the manufacturer. The assembly fit easily between the shroud and the water pump and when all was done the position of the fan was exact. The only negative was the adapter is too large for any wrench that I had but because the engine rotation is opposite the adapter thread I tightened the fan assembly by hand and the engine did the rest. Don't do that if you do not feel comfortable but it is the same principle as installing a saw blade on a table saw. Also, Amazon specifically showed this would not fit my Jeep, but the factory said it would work.The fan works great, really great! It is so much light than the stock fan and there is no big, heavy clutch robbing horsepower. My temp guage shows the engine running cooler and no change when pulling a 5' x 8' trailer with appliances.

This item did its job. Finish is nice. It however did not fit my 1977 f350 that it was bought for and Amazon said would fit. I had to modify it to fit my 3/4" water pump shaft.

Worked great

Good product, bolts were a bit too short.

Worked good!

Good fit, but needed a different size. Kept it for a spare. All hardware came with it.

not needed for flex-a-lite nylon fan for Jeep 4.0 install...as they stated on web site.Need some small modifications to make it fit like old one. cut out center and drill new holes. only took me about 30 min...much lighter and durable than old stock garbage

Just the right size to do the job for what I wanted

Perfect fit

Arrived in less then a week and fit perfectly and looks good

Nice fitting extension for flexolite fans. Bolts are grade 5, but should be grade 8 for the amount of torque subjected on the fan. Do yourself a favour and buy proper grade 8 bolts and throw the ones they send with the package before they snap and go through your radiator

Would buy again if needed.