RCA Cables - Silver Serpent Anniversary Edition Audio Interconnect Cable - High-End, High-Performance, Premium Hi-Fi Audio - 6 Inch Stereo PAIR (2 cables)

I bought two pieces of wire. These two conductors are well made, and look fairly decent. I can tell you that these wires will conduct electrons from one end to the other, but I would not ascribe any sort of audio characteristics to them, because I can't hear any difference. These are being used in an NAD amp between the preamp out and main amp in. Yes, these are nice wires and if you don't want to spend a lot of money on silver plated copper wires, get a pair of these wires. Yes, I would recommend them because the price is much better than some fancy wires at over $100. Before you make your purchasing decision, I have not noticed ANY difference at all between these wires and $2.99 wires. But they look nicer and beefier for 10X more cost.

I use these for turntable interconnects. I replaced a set of 1 meter Project 5P Connect-It Phono CC between my 6Perspex and phonoboxS preamp with these and there was an immediate and noticeable improvement. The other connect sounded very shrill, these lost none of the high end clarity but the shrillness was gone. Likely due to lower capacitance of the shorter silver serpent's playing nicer with my cartridge? At any rate, well-made, very reasonable price (the Connect-Its are over $100), and it improved the sound of my particular setup, to my ears at least.

Great little cable being used as a port saver of sorts on a computer I use for a DJ business. The inflexibility causes a bit of an issue, but nothing that can't be solved with a wire tie or two. Had a bit of a problem at first with the cables coming off the sound card's output connectors, but it turned out that I didn't push them on far enough. Works wonderfully now, and the quality is all you'd expect a $30 pair of 6 inch RCA cables to be - sublime.

Cables are ok and appear to be well built. BUT, one of the connectors fit loosely on the my amp/DAC setup and caused audible noise. I had to compress the outer conductor to get it to fit snugly enough to resolve that issue. So this was one disappointment with these cables given the $40 pricetag. No issues since doing that though. If these are handmade, then you'd think that a loose connector would have been weeded out through a simple QC test fit.

I am very happy with these cables. They are very high quality, very well built, have a very secure grip to my AMP and DAC. I have these hooked up to my Schiit Magni and Modi and the RCA connectors hold very well. The inside of the RCA connector has a small flexible ridge that creates a very sturdy and firm connection. I am also really happy with the sound of these cables. All my music comes through with a tad more transparency than I had before on my Sennheiser HD600's and the musical definition is top notch.

I will say that on first look this seem a significant cables. They have some weight and look well put together. When connecting to my nad amp The RCA did not grip tight at all. Very disappointing. There is a significant difference in the sound. Bass is more defined highs more vibrant. I figure a break in period is necessary so expect sounds to improve. Overall not to bad shame the connections aren't better

Well built and silent. Very short, so be sure your components are right next to each other.

I needed some new interconnects to go between my amp and preamp. These were perfect. Much improved definition and sound stage. Six inches was a perfect length for this. I may bite the bullet for 1/2 meter lengths for my other components. A silver plated bargain.